-

USES * Essentially a primer for new galvanised iron surfaces.

* Provides an excellent primed surface for topcoating directly withSparcolux Roof Paint or Sparcolux Iron Oxide Roof and StructuralPaint on galvanised iron roofs or Sparcolux Universal Undercoatand/ or Sparcolux Enamel on galvanised iron cladding .

GENERAL DATAType

Drying time @ 25°C

Recoating Viscosity Specific gravity Gloss Volume solids Weight solids Recommended dry fiIm thickness Spreading rate (theoreticaI)

Oil based, containing a minimum of 30% calcium plumbate as the anti-corrosive pigmentSurface: 8 - 10 hoursHard: 40 - 45 hours 24 hours ( overnight) 70 - 80 Krebs Units1,46 - 1,50 Eggshell 50 - 52% 70 - 72%

25 - 40 microns ( 1,0 - 1,6 mils) 12 - 20 sq.m/ litre

COLOUR RANGE Cream

Ready for use with brush or roller. This product should not be sprayed. Not normally thinned, but if necessary use Mineral Turpentine only.

APPLICATION

Thinner

Brush/Equipment wash Sparcolux Brushwash/Degreaser or Mineral Turpentine.

2/

CALCIUM PLUMBATE PRIMER

INTRODUCTION * Top quality galvanised iron primer

* Excellent adhesion and corrosion resistance

* Provides an excellent primed surface for topcoating with conventionalpaints

PROCESS DETA l LS Surface Preparatio n

Priming

Practical spread ing rate

New galvanised iron surfaces must be precleaned with Sparcolux Brushwash/ Degreaser, prior to the application of this product. Apply one coat for new work in accordance with the Practical Spreading Rate given below. For general maintenance, spot prime all bare areas. 9 - 15 sq. m/ l itre will give 25 - 40 microns dry (1 ,0 - 1,6 mils) allowing for 25% wastage over the Theoretical Spreading Rate.

PRECAUTIONS Not recommended for application to aluminium and light metal surfaces.

FLASH POINT 37°C ( 98° F)

PACK SIZES 25 Iitres 5 Iitres

PRODUCT DATA SHEET Sheet 2