By : Matt Iannacone Sammy Akato Stephen Zimmerman.
-
Upload
franklin-gibson -
Category
Documents
-
view
213 -
download
0
Transcript of By : Matt Iannacone Sammy Akato Stephen Zimmerman.
By : Matt Iannacone
Sammy Akato
Stephen Zimmerman
DesignOur design consists of
a Kenex box structure, a generator, and a fan.
As the fan turns due to wind power the magnets will rotate within the generator producing the voltage needed.
Fan DesignCreated out of balsa wood and tissue paperWater wheel styleSupported by KenexThree bladesExtremely light
Generator DesignInsulated wire wrapped
around a coke bottleWrapped 700 timesPlaced and supported in a
box structureEarth magnets run within
the coilsConnected to the fan
Mechanical and Electrical AspectsWind energy captured by the fanThe more wind the more rotationsMagnets rotateMagnets create electrical currentEnergy loss due to friction, generator resistance, and fan
flaws.
Construction IssuesThe generator
Difficult to createProblem with efficiency
The fanFragileSensitive to moisture
OverallProject was challengingTime consuming
EfficiencyEquationsPtheoretical = ½(ρAV3) – density(air) * surface area(fan) * air velocity
Ptested = VA – volts * amps = watts
(Ptested / Ptheoretical) * 100 = efficiency
ValuesPtheoretical = ½ * 1.225 * .0383866) * 1.73 = .115513 watts
Ptested = 1.4 * .0035 = .0049 watts
E = (Ptested / Ptheoretical) * 100 = 42.42% efficiency
ConclusionProject was successfulLearned basic concepts of
electricity and generatorsDevelopment of teamworkBetter materials could produce
a higher efficiencySpent $21.29This project is relevant because
at a large scale windmills are used to produce green electricity for everyday life.