By, LINSS T ALEX Edited By Sarath S Nair technologyfuturae
description
Transcript of By, LINSS T ALEX Edited By Sarath S Nair technologyfuturae
www.technologyfuturae.com
MODELING AND ANALYSIS OF INTERIOR PERMANENT
MAGNET SYNCHRONOUS MACHINE FOR HYBRID
ELECTRIC VEHICLES By,
LINSS T ALEX Edited By
Sarath S Nairwww.technologyfuturae.com
www.technologyfuturae.com
INDEX Introduction Modeling of IPM machinesAnalysis of IPM motorsRotor Design TopologiesPerformancesApplications IPM motors in Hybrid Electric VehiclesConclusionsReferences
www.technologyfuturae.com
INTRODUCTIONHEVs are gaining increased attention due
to their higher efficiencies and lower emissions.
HEV combines a smaller IC engine with a battery pack and an traction motor to drive the vehicle.
Requirements of traction machines include high efficiency and high performance.
An Interior Permanent Magnet(IPM) synchronous machine is used to obtain mechanical robustness,capability of flux weakening and high speed operation.
www.technologyfuturae.com
A one pole pitch cross sectional view of a 6-pole IPM machine with tangential magnet
configuration
MODELING OF IPM MACHINES
www.technologyfuturae.com
1.MAGNETIC MODELAverage air gap flux density,
CØ=Am/Ag, flux concentration factorBr- Remanence of the magnet
Contd…
www.technologyfuturae.com
Also,Parameters of above equations,
Contd…
www.technologyfuturae.com
g-air gap lengthKc-Carter coefficientμrec -relative recoil permeabilityAmm=t.l, cross-sectional area of the iron bridge
above the nonmagnetic barriers .t - Bridge width l-motor stack length.Bs-limit of leakage flux density in the bridge due to
saturation.
Contd…
www.technologyfuturae.com
Maximum value of first harmonic of the PM flux linkage,
Kwl-winding factorNph-winding turns per phaseP-number of pole pairsα-pole arc to pole pitch ratioD-inner diameter of stator
Contd…
www.technologyfuturae.com
The d-axis and q-axis inductances,
Contd…
www.technologyfuturae.com
Where Kd and Kq are defined as,
ge- effective air gap,
Contd…
www.technologyfuturae.com
2.ELECTRICAL MODELFlux distribution in the air gap is assumed to be
sinusoidal and the iron loss and magnetic saturation are not considered.
Contd…
www.technologyfuturae.com
From the motor vector diagram voltage equations are,
The motor torque,
Contd…
www.technologyfuturae.com
id and iq are the d-axis and q-axis components of stator current vector Is.
Magnitude of stator current vector is,
The design optimization is carried out under the condition of maximum torque per Ampere control
Contd…
www.technologyfuturae.com
Contd…
www.technologyfuturae.com
Flux linkage and inductances can be normalized as,
Contd…
www.technologyfuturae.com
IPM motor is an induction start but synchronously run high efficiency motor.
IPM must overcome the magnet brake torque during starting process.
Developed power Pd is,
ANALYSIS OF IPM MOTORS
www.technologyfuturae.com
In IPM motors inserting permanent magnets in various arrangements and magnet polarity orientations below the conduction cage of the IPM rotor .
An IPM motor develops driving torque due to both permanent magnet excitation and reluctance variation.
Developed torque Td is,
Contd…
www.technologyfuturae.com
First term is permanent magnet excitation torque component.
Second term is reluctance torque component Efficient utilization of reluctance torque
component is most critical for intensive flux weakening operations and efficiency improvements in HEV and electric traction drive.
Contd…
www.technologyfuturae.com
NdBFe magnets having high B and very large H is used for rotor design.
Two types 1)Straight type 2) V-type Straight type has buried permanent magnet
materials
ROTOR DESIGN TOPOLOGIES
www.technologyfuturae.com
V shape rotor with permanent magnets having polarity arrangement without conduction cage for optimum air-gap flux is used in HEV and traction application.
Contd…
www.technologyfuturae.com
Torque to weight ratio significantly improved by operating the IPM motor at 650-Vdc from smart dc-dc converter.
The light load loss decreased primarily by employing high-grade silicon steel.
Contd…
www.technologyfuturae.com
3-phase,4-pole,Y-connected,200V 1 hp IPM motor with NdBFe magnets comparing with a .6kW,3-phase,4-pole,200V induction motor
PERFORMANCES
www.technologyfuturae.com
The efficiency and power factor as well as their product of the IPM motor is over 35% better than that for identical rated induction motor.
The energy efficiency aspect is a key factor for wide spread high performance applications of IPM motor drives.
Contd…
www.technologyfuturae.com
Ventilation fans Air conditioner/heat pump compressors Cranes Lift/escalators Blood pumps Ship propellers Electric locomotive traction drives Electric and Hybrid Electric Vehicles
APPLICATIONS
www.technologyfuturae.com
IPM motors provides wider torque-speed range under severe size, weight and cost constraints.
IPM motors fulfill the requirements for smooth vehicle propultion,low vibration/noise and high degree of driving comfort.
IPM MOTORS IN HYBRID ELECTRIC VEHICLES
www.technologyfuturae.com
Low Speed
Working of IPM motor in Hybrid Electric Vehicles
www.technologyfuturae.com
Cruising
Contd…
www.technologyfuturae.com
Braking
Contd…
www.technologyfuturae.com
www.technologyfuturae.com
At 650V level, a new reduction gear is incorporated for further reduction in axle torque to about 50%,thereby reduce motor size significantly.
Contd…
www.technologyfuturae.com
Application of IPM motors in HEVs
www.technologyfuturae.com
Modeling and analysis of IPM machines were discussed.
Rotor design features for specific applications was studied.
Comparative performances of IPM and induction motors was discussed.
Several examples of successful applications were high lighted.
High performance IPM motors have emerged as the choice of energy efficient and environmentally friendly Hybrid Electric Vehicles.
CONCLUSIONS
www.technologyfuturae.com
[1] M.A.Rahman, “Permanent Magnet Synchronous Motor-A review of Design Art", Proceedings of International Conference of Electrical Machines-ICEM’80,Athens,Greece,Sept.15-17,1980,pp.312-319.
[2] M.A Rahman,T.A.Little and G.R Slemon, “Analytical Models for Interior-Type Permanent Magnet Synchronous Motors”,IEEE Transactions on Magnetics,vol.MAG-21,No.5,1985,pp.1741-1743.
[3] M.Kamiya, “Development of Traction Drive Motors for the Toyota Hybrid System”,Proc.IPEC-2005,Niigata,Japan,April 4-8,2005,pp.1474-1481
[4] T.M.Jahns, G.B.Kiliman and T.W.Neumann, “Interior PM Synchronous Motors for adjustable Speed Drives”, IEEE Transactions on Industry Applications,vol.23,No.4 1987,pp.681-689
[5] M.A Rahman, “IPM Motor Drives for Hybrid Electric Vehicles”,IEEE Transactions 2007.
REFERENCES
www.technologyfuturae.com
[6] L.Chang,”Comparison of ac drives for electric vehicles-A report on experts opinion survey,” IEEE AES System Magz. Pp.7-10,Aug.1994.
[7] Arash Hassanpour Isfahani and Siavash Sadeghi, “Design of a Permanent Magnet Synchronous Machine for the Hybrid Electric Vehicle”,IEEE Trans.vol.45,pp.566-570,Dec 2007
Contd…
Log On to www.technologyfuturae.com
Technology FuturaeTechnical Presentations, Research Reviews, New designs & Developments
www.technologyfuturae.com
THANK
YOU