Button Up Window Treatment
-
Upload
brigitte-morue -
Category
Documents
-
view
214 -
download
1
description
Transcript of Button Up Window Treatment
-
2" 2"
ILLUSTRATION 1 ILLUSTRATION 2 ILLUSTRATION 3
Button Up Window TreatmentRead all instructions carefully. 1/2" seam allowance included inall measurements.Finished size: 29 1/2" x 54"; fits 1" round rodMaterials Needed:Apple Orchard Large Whole Apples Fabric VIP #61141-J 1 3/4 YdsApple Orchard Apple Slices Fabric VIP #61142-Z 1 3/4 YdsIron-On Medium Weight Interfacing 1 3/4 Yds Grosgrain Ribbon 1/2 YdButtons 1" 6Note: Adjust yardage based on your window dimensions.
1. Measure the length and width of the inside of the window frame andadd 1/2" to these measurements.
2. Cut one panel from each fabric and the interfacing the size measured.3. Iron the interfacing following manufacturers directions to the wrong
side of the whole apple panel.
4. Mark 2" down from the sides of the top of the fabric. This will be for the casing. Mark the center and 1"in from each side on the bottom of the panel. Cut 3-4 1/2" pieces of ribbon. Make a loop and sew to theright side of the bottom of the panel centering on your marks with the raw edges even. Illustration 1
5. With right sides sew the two panels together starting at the 2" mark on the side, sewing down the sideacross the bottom, leaving a 6" opening for turning and up the other side to the 2" mark. Sew across thetop. Illustration 2
6. Turn, press and hand sew the bottom opening closed.7. With a disappearing ink pen or light pencil mark draw a line from the 2" mark across the fabric to the
other 2" mark. Sew across this line to form the casing for the rod.8. Sew the 6 buttons to the front of the window treatment. Sew 3 buttons across the top and 3 buttons halfway
down aligning them with the loops. Illustration 3