BS186GB 英文说明书(未转曲) · right earphone alternately ˜ashing red and blue, mobile...
Transcript of BS186GB 英文说明书(未转曲) · right earphone alternately ˜ashing red and blue, mobile...
Specifications
Structure Sketch
*The time mentioned above may vary due to user's operation mode anddevice settings.
1)MFB(multifunction button)2)Indicator light(MIC)3)Speaker4)The charging contact point
5)ON/OFF for the base6)Charging base indicator7)Micro USB charging port
Set Uppress MFB for 2 seconds to turn on
Turn on pairing fuction on your device, connect to “BS186GB-R”
Pick up the two earphones
from the charging base to
turn on
IWait until to see red & blue LED �ashing, it is under pairing mode
5
1
2
3
4
76
Version:
Pro�les Supported:
Audio Decoding Protocol:
Transmission Power:
Operation Range:
Frequency Range:
Battery of Earphone:
Charging Voltage of Earphone:
Charging Time of Earphone:
Battery of Base:
Charging Voltage of Base:
Charging Time of Base:
Charging Earphone Times from
Charging Base:
Music Playing Time:
Talk Time:
Standby Time:
Driver:
Driver sensitivity :
Driver impedance:
Driver frequency ring range:
Dimensions of Charging
Base(mm):
Dimensions of Earphone(mm):
Weight(one Earphone):
Total Weight :
V5.0
HSP, HFP, A2DP, AVRCP
SBC, AAC
Class 2
Up to 10 meters
2.4GHz-2.48GHz
45mAH Li-polymer Battery
DC 5 ± 0.25V
About 1.5 hour
460mAH Li-polymer Battery
DC 4.75-6V
About 1.5 hours
2-3times
Up to 6 hours
Up to 6.5 hours
Up to 100 hours
6mm
93db/1kHz
16Ω±15%
20Hz-20kHz
L80×W33×H31
L19.5×W19.5×H26
About 4.8g
About 58g
or:
Single TapDouble TapPress and Hold
Multi-function Buttons
Previous track: Hold L
Next track: Hold R
Lower volume: Double tap on L
Increase volume: Double tap on R
Pause: Tap R
Play: Tap either L or R while pause
Pick up call: Tap L or R
End call: Tap L or R
Rejecting call: Hold L or R
Tap L to activate Siri or Google Assistant
Two-calling handling is not supported on all devices
1. Press and hold the R to end thecurrent call and answer the second call
2. Tap L or R to hold the current call and answer the second call
3. After picked up the second call, tap L or R to switch between calls
4. Hold and press L or R to end either call
2s
Turn on one of the earphone
Turn on pairing fuction on your device, connect to “BS186GB-R” or “BS186GB-L”
Stereo or Mono Earphone Usage
The BS186GB come with one “master” - “R” earphone, one “slave” - L earphone. When you turn on the earphones after they connected, “master” �ash red and blue alternately, “slave” �ash blue.
Bluetooth ON
Connect
BS186GB-R
Status No. Status Earphone Performance
1
2
3
5
4
6
The indicator light of the right earphone �ashes blue once every
5 seconds
Theearphone(R)
Single Pairing
TWS Pairing
Standby Mode
Call Mode
Earphone Charging Mode
Charging Base Charging Mode
7
8
9 The indicator light �ashes red once every 20 seconds
Power On State
Power O� State
When in a call, the indicator light of the right earphone �ashes red every 5 seconds
The indicator light of earphone(R) �ashes red and blue alternately
The indicator light of the earphone is red when being charged, and will turn o� automatically after being fully chargedThe indicator lights of the charging base �ashes when being charged, and four lights are on after being fully charged
After TWS pairing successed, the indicator light of right earphone alternately �ashing red and blue, when the right earphone pairing successful with mobile phone, the indicator light �ashes blue
The indicator light �ashes red for 3 times.
The indicator light �ashes blue for 3 times and then �ashes red once every 5 seconds
Low Voltage Alarm State
LED Indicator
Bluetooth ON
Connect
BS186GB-R
Second
MasterSlave
Mono
Stereo
Note: If you want to use stereo, don’t pick “BS186GB-L”. Restart or reset the earphones if you cannot �nd “BS186GB-R”
BS186GBTWS Earphone User Manual
Please keep the earphone away from children.
Earphone should be used with the compatible devices which support wireless technology. This allows you make two calls and enjoy the music streaming at any time freely. Please also read this user manual carefully before using the earphone, and also read your device's user manual regarding the device function, and pay attention
ReconnectionWearing:
Erect and place them into the cochlea
Slightly rotate earphone until it �rm
Make the earphone to cochlear edge tightly
Problem Reasons SolutionsCan not turn on Battery low Charge earphones for 2-3 hours
Low battery Charge headset for 2-3 hours
Hearing echo
Noise in call
Wrong pairing Paired again
Too many pairing records Reset
DC power supply problem
Charging base battery low Charge both the earphones and charging base for 2-3 hours
The two earphones TWS pairing failure/TWS paired successful but can not �nd the headset(R)
Trouble Shooting
Low voice on call or music Wrong wearing
Follow the wearing instruction
The earphones couldn’t being charged in charging
Relocate the earphones to ensure it’s full touched with the charging pins. Ensure the charging button is turned on.
Envrionment interference caused or distance between earphone and mobile is too
press and hold MFB for 2 seconds or pick up the earphone from charging base to turn on -- wait for few seconds, two headset connected automatically -- the headset will reconnect the mobile phone which is paired before --
Reset
O�-stage earphones, press both earphones and hold for 5-8 seconds until you see pink light or heard short 3 beeps. (operation to delete the internal pairing)LED: blue – red – pink Voice: power on – power o� – beep beep beep
Turn on the earphones, wait for 5-10 seconds to let the earphones pair by themselves (operation to build up the internal pairing). LED: blue – red/blue – blue – red/blue just on right earbuds
earphone
Charging - Red LED on Finish charging - LED o�
Charging
Charging Button1. Switch on the button to start charging and activate auto-pairing of earphone.2. Switch o� the button to save the power if not use the
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o� and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit di�erent from that to which the receiver is connected.-Consult the dealer or an experienced radio/TV technician for help
Changes or modi�cations not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. Put the earphone (L)(R) to the corresponding position in the bottom of the charging base, and press the charging base switch.
Can not turn on by picking up the
No light on charging base when charging
check the charging cable is pluged in. Ensure the charging button is turned
No light on earphones when
Turn o� automatically
No sound after paired
Adjust the volume or change place
Change a place or move closer the earphones and
Volume is too loud or environment is noisy