Bridge Mode Setup - Netcom · Note: For ATM interface, the descril)tor string is (portld vpi vci)...
4
Bridge Mode Setup (RTA1025W Rev 2)
Transcript of Bridge Mode Setup - Netcom · Note: For ATM interface, the descril)tor string is (portld vpi vci)...
Bridge Mode Setup(RTA1025W Rev 2)
Bridge Mode
This guide will take you through the steps required to set your modem to bridged mode.
1. Open your web browser and go to the address http://192.168.1.1, using admin as theusername and password.
2. Select “Advanced” from the menu at the top of the page.3. Select “Internet” from the menu on the lefthandside of the page and then
“Connections” from underneath this.4. Remove the “pppoe” connection by placing a tick in the “Remove” checkbox as per
the screenshot below.5. Click the “Remove” button.6. Once the “pppoe” connection has been removed, click the “Add” button.
7. Ensure “atm0/(0_8_35)” is selected from the pulldown menu as per the screenshotbelow.
8. Select “Bridging”9. If you wish to change your connection, enter a new name in the “Enter Service
Description” section.
10. Click “Save/Apply” to save your connection settings.11. Once saved, click “Local Network” from the menu on the lefthandside of the page.12. Click on “DHCP Server” from underneath this.
13. Select “Disable DHCP Server” as per the screenshot below.
14. Click the “Apply/Save” button to save the changes.
Your modem will now reboot. When it has finished restarting, it will then be in bridgedmode.
