Boiling and Boiling Point

25

description

Boiling and Boiling Point. FIGURE 12-21. Boiling water in a paper cup. Liquid boils at low pressure. FIGURE12-21. Boiling water in a paper cup. Class Example – Clapeyron Equation:. - PowerPoint PPT Presentation

Transcript of Boiling and Boiling Point

Page 1: Boiling and Boiling Point
Page 2: Boiling and Boiling Point

Slide 2 of 61

Boiling and Boiling Point

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

• FIGURE 12-21• Boiling water in a paper cup

Liquid boils at low pressure

FIGURE12-21Boiling water in a paper cup

Page 3: Boiling and Boiling Point

Class Example – Clapeyron Equation:

• 1. The vapor pressure of acetone, (CH3)2C=O, is 10.0 mm Hg at -31.1 oC. What is the vapor pressure of acetone at 15.0 oC if the enthalpy of vaporization of acetone is 31.3 kJ mol-1? (Great care with significant figures is required!) Does the answer make sense in terms of the kinetic theory of matter? If so, why? Use the data given to estimate the normal boiling point of acetone.

Page 4: Boiling and Boiling Point

Clapeyron Equation

• 2. How could you employ the Clausius-Clapeyron equation to obtain thermodynamic data without using calorimetry? What types of thermodynamic data can be obtained? What experiments would you conduct to determine a ∆Hvaporization value for liquid water using the Clapeyron equation?

Page 5: Boiling and Boiling Point

Coexistence Curves

• Under a range of temperature and pressure conditions one can have liquid and vapor (gas) in dynamic equilibrium. Gas phase molecules are entering the liquid at the same rate as liquid phase molecules are evaporating. (No heat needs to be supplied for this process to occur. Why?) The simplest cases involve a pure liquid and a pure gas in equilibrium.

Page 6: Boiling and Boiling Point

Slide 6 of 61

Vapor pressure curves of several liquids

• FIGURE 12-18

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

Page 7: Boiling and Boiling Point

Coexistence Curve Calculations

• 1.We used the Clausius-Clapeyron and a vapor pressure at one temperature to predict the vapor pressure at a second temperature (given ΔHVAP). 2.We also used a vapor pressure at one temperature (and ΔHVAP) to calculate the normal boiling point of a liquid (same as 1.?) 3. We can use the vapor pressure of a liquid at two temperatures to find ΔHVAP. Mention ΔHSUBLIMATION ?

Page 8: Boiling and Boiling Point

Calculations Related to Coexistence Curves

• One can imagine putting a volatile liquid in an empty container and seeing one of two results:

• 1. All of the volatile liquid evaporates. In this case PGas will be less than the equilibrium vapor pressure of the substance/liquid.

• 2. Only some of the liquid eventually evaporates. Here Pgas equals the equilibrium vapor pressure.

Page 9: Boiling and Boiling Point

Class Example:

• 1. A total of 3.00 g of liquid water was placed in an evacuated (initially) 12.0L container maintained at a temperature of 80.0 0C. Will a liquid/gas equilibrium be established? What piece of data is required to solve this problem? If no liquid/gas equilibrium is established, determine how much additional liquid water is required to have some liquid in equilibrium with H2O(g) in the container.

Page 10: Boiling and Boiling Point

Critical Points

• The normal boiling point of water is 100 oC. At this temperature the vapor pressure of water is exactly 760mm Hg (the normal average atmospheric pressure at sea level). If we heat water in a sealed container all of the steam that is formed is trapped above the liquid water. The additional steam formed increases the pressure of the gas above the liquid and “naturally” the boiling point rises.

Page 11: Boiling and Boiling Point

Critical Points

• There is a limit to how high we can raise the temperature of a liquid/gas mixture and still have a well-defined two phase equilibrium. One eventually reaches a temperature/pressure point beyond which there is only one fluid phase. The specific T and P where this occurs is referred to as the critical point of the substance.

Page 12: Boiling and Boiling Point

Slide 12 of 61

The Critical Point

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

• FIGURE 12-22• Attainment of the critical point for benzene

Page 13: Boiling and Boiling Point

Critical Points

• The next slide shows critical point data for a number of substances. Do the “permanent” and “non-permanent” gases differ appreciably if one considers intermolecular forces?

Page 14: Boiling and Boiling Point

Slide 14 of 61 Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

Page 15: Boiling and Boiling Point

Other Coexistence Curves

• For substances such as molecular iodine which sublimes readily at ambient temperatures we can have another type of equilibrium

• I2(s) ↔ I2(g)• At a particular temperature and pressure the

vapor pressure of solid iodine is well defined. We can construct a coexistence curve illustrating the T’s and P’s where the solid and gas are in equilibrium.

Page 16: Boiling and Boiling Point

Slide 16 of 61

Some Properties of Solids

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

Figure 12-23

Cooling curve for water

Figure 12-24

Heating curve for water

Melting, Melting Point, and Heat of Fusion

H2O(s) H2O(l) ΔHfus(H2O) = +6.01 kJ/mol

Page 17: Boiling and Boiling Point

Slide 17 of 61 Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

Page 18: Boiling and Boiling Point

Slide 18 of 61

Sublimation

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

• FIGURE 12-25

• Sublimation of iodine

ΔHsub = ΔHfus + ΔHvap

= -ΔHdeposition

Page 19: Boiling and Boiling Point

Phases Changes – Signs of ΔH’s:

• The left to right processes below are endothermic (remember intermolecular forces!).

• C2H5OH(s) → C2H5OH(l) → C2H5OH(g)• The opposite processes are necessarily

exothermic. We will soon see processes where ΔH for ionic deposition process is extremely exothermic (Eg. Na+(g) + Cl-(g) → NaCl(s)).

Page 20: Boiling and Boiling Point

More Coexistence Curves:

• We can usually represent (s) ↔(g) and , as well, (l) ↔ (g) coexistence curves on the same graph. We can also look at (s) ↔ (l) coexistence curves – in this case we see melting point values that change very slowly as the pressure changes. Plotting all three coexistence curves (and sometimes more!) on a single graph gives us a phase diagram.

Page 21: Boiling and Boiling Point

Slide 21 of 61 Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

• Phase diagram for iodine

Iodine

Page 22: Boiling and Boiling Point

Slide 22 of 61

Carbon Dioxide

Copyright © 2011 Pearson Canada Inc.General Chemistry: Chapter 12

• Phase diagram for carbon dioxide

Page 23: Boiling and Boiling Point

Critical Point and Triple Point

• We’ve discussed the critical point. The previous two graphs show in each case three coexistence curves meeting at one (unique!) point. This so-called triple point is well defined for a pure substance. At the triple point we have solid, liquid and gas phases simultaneously in equilibrium. What triple point is central to life in St. John’s?

Page 24: Boiling and Boiling Point
Page 25: Boiling and Boiling Point