Benelli TRK 502 S U P P L E M E N T A R Y M A N U A L...Benelli TRK 502 2017-Remove the side black...
2
www.healtech-electronics.com S U P P L E M E N T A R Y M A N U A L for iQSE-1 + QSX-F2C PAGE 1/2 Remove the seats. Benelli TRK 502 2017- Remove the side black plastic covers. Plug the QSX connectors in-line with the fuel injector connectors. (black, 2-pole connectors below the fuel tank.)
Transcript of Benelli TRK 502 S U P P L E M E N T A R Y M A N U A L...Benelli TRK 502 2017-Remove the side black...
www.healtech-electronics.com
S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSX-F2C
PAGE 1/2
Remove the seats.
Benelli TRK 5022017-
Remove the side black plastic covers.
Plug the QSX connectors in-line with the fuel injector
connectors.(black, 2-pole connectors below the fuel tank.)
www.healtech-electronics.com PAGE 2/2
Connect the QSH black wire terminal to the battery
negative terminal.
Mount the QSE sensor under the bolt of gearbox shaft.
(Tighten the bolt by about 5-6 Nm.If you do not have a torque wrench,tighten the bolt until the shift arm
is tight on the gearbox shaft.)
S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSX-F2C
Benelli TRK 5022017-
Typical position for theQuickShifter easy.
Secure the module properly.