Beam Dyeing
2
05.21.2 013 BEAM DYEING PREPARATION PARAMETERS 1) The density of the beam should be 420 to 480 gm/dm 3 (average 450 gm/dm 3 ). 2) The traverse area should be 10 mm, if traverse increases then the density will be decreased. 3) The density of the beam should be same in the side of the flanges, otherwise pressure will be leaked in flanges area. 4) For lower EPI the traverse should be higher. 5) For higher count, if traverse is lower than the density will be higher. 6) The knotting should be proper in the beam. 7) No of beam should be prepared either 16 or 4 8) Liquor ratio should be adjusted to the level of the beam height. 9) All the yarns of the ends should be knotted in one side of the beam to collect the dyeing sample. 10) Before dyeing the beam should be wetted at a pump speed of 50-60% to remove the entrapped air. 11) Pump speed of the dyeing machine should be controlled properly to prevent the beam leakage during dyeing. 80% speed is acceptable, the speed should be lower in case of leaked beam. 12) After bleaching, the beam leakage should be checked. AKIJ TEXTILE MILLS LTD Tel 027710004 Fax 027710003 Golora, Manikgonj www.akijtextilebd.com [email protected]
-
Upload
saif-rahman -
Category
Documents
-
view
4 -
download
1
description
beam dyeing factors
Transcript of Beam Dyeing
05.21.2013Pg.02
05.21.2013
BEAM DYEING PREPARATION PARAMETERS1) The density of the beam should be 420 to 480 gm/dm3(average 450 gm/dm3).2) The traverse area should be 10 mm, if traverse increases then the density will be decreased.3) The density of the beam should be same in the side of the flanges, otherwise pressure will be leaked in flanges area. 4) For lower EPI the traverse should be higher.5) For higher count, if traverse is lower than the density will be higher.6) The knotting should be proper in the beam.7) No of beam should be prepared either 16 or 48) Liquor ratio should be adjusted to the level of the beam height. 9) All the yarns of the ends should be knotted in one side of the beam to collect the dyeing sample.10) Before dyeing the beam should be wetted at a pump speed of 50-60% to remove the entrapped air.11) Pump speed of the dyeing machine should be controlled properly to prevent the beam leakage during dyeing. 80% speed is acceptable, the speed should be lower in case of leaked beam.12) After bleaching, the beam leakage should be checked.13) In case of leaked beam, the leaked area should be wrapped tightly with RFD cloth.14) If the beam is leaked in top side, then it should be lifted & rotated in the bottom position.15) Dyeing should be made without any addition of dyes.
Prepared byMd. Lutfor RahmanManager (Yarn dyeing)[email protected]
AKIJ TEXTILE MILLS LTD
Tel 027710004Fax 027710003Golora, [email protected]
