Assembly instructions for Marley Abyssinia Beach Cruiser

Assembly of Marley Abyssinia model is very simple and can be done at home.

Please follor the instructions below and email us with any questions.

Open box with care, sharp staples hurt.

Unpack bicycle leaving cardboard underneath wheels to avoid scratching beach cruiser.

Carefully cut all plastic ties with scissors.

Stand up beach cruiser with rear stand in vertical position.

Unscrew nuts and washer from both sides of front wheel, insert front wheel into front fork axle.

Apply washer to front axle and then firmly screw on lug nut.

Open small brown box, check letters L and R on the bottom of pedals. Pedal with R goes on the right side, pedal with L goes on left side from the driver’s perspective. Screw on tight.

Remove saddle from plastic wrapping. Insert smaller end of tube found in the brown box into saddle, tight screws on either side of the saddle.

Open plastic bag containing reflectors; faster the black reflector housing on the tube connected to the saddle, adjust with with screw driver.

Insert tube with seat into bike body, creating saddle.

Screw rear reflector under seat with supplied nuts and bolts.

Tighten screw on right side under seat preventing seat from rotating. Move left hand metal strip backwards to tighten seat.

Insert handle bars into top front fork housing.

Tighten handle bars with L shaped hex wrench. Adjust handle bars to your personal optimal angle.

Screw the front reflector on the front of beach cruiser.

Remove all plastic protective wrappings from the body of beach cruiser.

Enjoy your new beach cruiser!