Battery Maintenance - ROG Home · PDF fileClean all Surfaces Using DI Water Only. Dust Allows...
Transcript of Battery Maintenance - ROG Home · PDF fileClean all Surfaces Using DI Water Only. Dust Allows...
Battery Maintenance
Installed: 11/08/14
(2) 12V Interstate SRM-27 BatteriesEA
Rubber / LatexGloves
Eye ProtectionInsulated Tools
Exercise Care: Use Insulated Tools
Disconnect Battery Switch
Disconnect All Battery Leads(4 Total Posts on Dual Batteries)
14 MM Socket
Exercise Care: Insulated Tools Should Be Used
CorrosionIdentify Corrosion
Identify Corrosion
Use Brass and Steel Brushes
Clean / Remove Corrosion
Use Baking Soda / Water Mix to Nuetralize Battery Acid.
Rinse Thoroughly.
After Cleaning
Clean / Remove Oxidation
- Before -
Clean / Remove Oxidation
- After -
Remove Caps (Unless Maintenance Free)
Verify Water Levels.(See Diagram)
Purchase a Battery Tester
AutoZone$5
Specific Gravity Readings
Fill to Line
Read Needle
6V / 12V / 24V Systems
Fill Line
Needle
Instructions on Back
For Those Who Might Require a Little More Precision
Use Distilled Water. NOT Tap Water.
Clean all Surfaces Using DI Water Only. Dust Allows for
Voltage Tracking Between the Positive and Negative
Terminals.
Reconnect Positive and Negative Connections.Replace Fluid Caps.
Replace Battery Covers / Vent Tubes and Secure.
Verify Terminal Connections are Clean and Tight
*TIP: Nut Drivers Work Best
Verify Negative Connections are Clean and Tight
Verify Ground Connections are Clean and Tight
Verify Hydraulic Connections are Clean and Tight