Basic Fuel Injection System Heavy Equipment Technician Agricultural Equipment Technician Second...
-
Upload
fay-hutchinson -
Category
Documents
-
view
218 -
download
0
Transcript of Basic Fuel Injection System Heavy Equipment Technician Agricultural Equipment Technician Second...
Basic Fuel Injection System
Heavy Equipment TechnicianAgricultural Equipment Technician
Second Period
Diesel Fuel Injection Systems and Tune-Up
190203c
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 1 - Optimum crank angle.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 2 - Change in timing with an increase in engine speed.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 3 - Atomized injector spray.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Table 1 – Different methods of metering.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 4 - Fuel spray penetration.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 5 - Multi-plunger injection pump system.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 6 - Fuel system with unit-type injectors.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 7 - Fuel tank.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 8 - Primary and secondary fuel filters.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 9 - Combination primary filter and water separator.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 10 - Transfer pump locations.
© Her Majesty the Queen in Right of the Province of Alberta by the Minister of Advanced Education. 1998
Figure 11 - Multi-plunger injection pump and high-pressure fuel lines.