Balloon Powered Car

8
Lea Tomarong Ariel Manalang Aroosa Munir Matthew Victoria Shim Pandapatan Mark Garin C.A.R

Transcript of Balloon Powered Car

Page 1: Balloon Powered Car

Lea Tomarong

Ariel Manalang

Aroosa Munir

Matthew Victoria

Shim Pandapatan

Mark Garin

C.A.R

Page 2: Balloon Powered Car

C.A.R

Page 3: Balloon Powered Car

to create a balloon

powered race car for

maximum speed and distance

Page 4: Balloon Powered Car

BalloonSticks2 CdsSpray paintStrawsTape 8 plastic lids from water bottlesStyro Board Glue GunRubber bondScissors and CutterClay

Materials:

Page 5: Balloon Powered Car

1. Prepare the design of the car. Draw it on a piece of paper. Use your imagination in doing this.

2. Ready the materials that you needed3. Start the project

> For the body, Cut the board into what shape you would like it to be. Use cutter or scissors in doing this.

>For the wheels, The plastic lids and Cd will be used. Use a scissors/cutter to make a hole in each lid, just big enough for a bamboo sticks to fit through. The 2 lids should stick together to make a wheel. Use a tape to merge them.

Procedure:

Page 6: Balloon Powered Car

>Glue gun the other two plastic lids in the cd and put the bamboo sticks through the hole.

> Use the sticks to combine the body and the wheels. Tape it or glue gun the other materials.

> Make a hole/cut a square-shape in the top of the body. Place the hole/neck of the balloon below the board and stick it with your tape. Also, place a straw inside the balloon.

> Make a driver using clay. It should have the seatbelt and a chair.

> Paint the whole car using the spray paint.> Place the car on a clear, smooth surface.> Inflate the balloon to try its effectiveness.

Page 7: Balloon Powered Car

10x faster than any other cars Light weight 98.99 % made of recyclable

materials. ( even the straws, board and sticks, etc.)

New design Environmental-friendly Easy to use

Innovations: