Ballasted PennLUG R104 Curve Track - L-Gaugel-gauge.org/downloads/Ref009BallastR104CurveRevA.pdf ·...
11
Parts List Notes Instructions are for a single curve track section. Multiply part quantity as required for multiple curves. 32x required for complete circle. This ballast method requires ME Models R104 curves (P/N ME901-104) Parts shown in yellow can be substituted with any other colour. PennLUG variation ! These instructions use techniques which may induce mechanical stress on individual parts. Use at your own risk. Ballasted R104 Curve Track Custom LEGO ® set instructions This set is not an official set. LEGO ® is a trademark of the LEGO group of companies which does not sponsor, authorize or endorse this product. Reference Instructions Sheet 009 A Rev Ballast method designed by Anthony Sava
Transcript of Ballasted PennLUG R104 Curve Track - L-Gaugel-gauge.org/downloads/Ref009BallastR104CurveRevA.pdf ·...
-
Parts ListNotes
Instructions are for a single curve track section. Multiply part quantity as required for multiple curves. 32x required for complete circle.
This ballast method requires ME Models R104 curves (P/N ME901-104)
Parts shown in yellow can be substituted with any other colour.
PennLUGvariation
!These instructions use techniques which may induce mechanical stress on individual parts. Use at your own risk.
Ballasted R104 Curve Track
Custom LEGO® set instructionsThis set is not an official set. LEGO® is a trademark of the LEGO group of companies which does not sponsor, authorize or endorse this product.
Reference Instructions Sheet 009 ARev
Ballast method designed by Anthony Sava
