BACK COVER FOLD FRONT COVER MAR 2018 TECHNICAL …

THE TRULY INDEPENDENT LEADER IN ENGINE MANAGEMENT AND

MECHATRONIC PRODUCTSim-group.com.au

MAR 2018

newsFRONT COVERBACK COVER

TECHNICALBULLETIN

Renault Clio, Megane

C649GENIgnition Coil - GEN OEM

Nissan Navara, Pathfinder

VS202GENTurbo boost control valve

HOLDEN COMMODORE VE / STATESMAN WM / CAPRICE WM SERIES - STOP LIGHTS NOT OPERATING DUE TO (BCM) BODY CONTROL MODULE FAILURE

This month’s featured product is a new genuine alternative Goss Fuel Pump Module to suit BMW E60/E61 5 series. Goss is well known in the Australian Automotive Aftermarket for its genuine quality direct replacement fuel pumps. All Goss fuel pumps are supplied with the correct strainer to do the right job first time.

The Goss brand is continually expanding its range of quality aftermarket fuel pumps, fuel pump modules, fuel tank sender units as well as ignition coils and rotation sensors.

Visit Goss.com.au

GE518 - BMW 5 E60 / E61 5 Series Fuel Pump Module

NOWAVAILABLE

FOLD

FOLD

Mercedes Benz W163

ESM04REPElectronic shift module

Hyundai i30 FD

ECMSIM2KREP Electronic control module

Porsche Cayenne, Panamera

C636Ignition Coil

Honda Accord / Odyssey

C638Ignition Coil

Audi Q7 / Porsche Cayenne (R/H/S)

GE514Fuel Pump Module

Audi Q7 / Porsche Cayenne (L/H/S)


You can visit www.injectronics.com.au for more details or to book in a repair and to locate your nearest reseller.

Engine: 3.0L, 3.6L & 6.0L Year: 2006-2013

Body Control Module Part no #15921353

Injectronics’ technical support are regularly contacted by customers enquiring about the stop lights either not operating or staying illuminated on their Holden Commodore VE series or Statesman/Caprice WM series. In most cases this problem arises after the vehicle has been used for towing purposes. This may be caused due to overloading the circuit or a dead short.

As with many vehicles today the BCM controls the operation of the stop lights including the centre high mounted stop lamp. The BCM provides a 5-volt reference voltage & a low reference signal to the Brake Pedal Position Sensor (BPPS). When the brake is applied, the BPPS sends a signal proportional to the pedal travel to the BCM. The BCM supplies battery voltage to the stop lamps, ECM & TCM. The stop lamps will not operate unless the ignition is in the ON position.

Injectronics can test and repair these BCM’s for stop light failure avoiding the need to reprogram a brand new replacement unit saving time and money. The BCM on the affected vehicles is located on the RH side of the steering column and can be accessed by removing the steering column panel/fuse panel cover.

Prior to reinstalling the BCM customers are also advised to have the stop lights and associated wiring checked on the vehicle, as well as the trailer to avoid any further damage reoccurring.

*Repair service

*Repair service

*Repair service

GE518

news

FOLD

FOLD

THE TRULY INDEPENDENT LEADER IN ENGINE MANAGEMENT AND MECHATRONIC PRODUCTS

THE TRULY INDEPENDENT LEADER IN ENGINE MANAGEMENT AND MECHATRONIC PRODUCTS

JUST A SAMPLE OF OUR CONTINUALLY INCREASING

RANGE OF GENUINE OEM AND AFTERMARKET AUTOMOTIVE ELECTRONIC COMPONENTS.

JUST A SAMPLE OF OUR CONTINUALLY INCREASING RANGE OF GENUINE OEM AND AFTERMARKET AUTOMOTIVE ELECTRONIC COMPONENTS.

INSIDE RIGHTINSIDE LEFT

Lexus RX300, RX330, RX350 / Toyota Aurion, Kluger

OX853GENOxygen Sensor - GEN OEM

Suzuki Grand Vitara



Honda Accord CL, CM Honda Civic ES, Integra DC


Audi A3, A4, A8 / VW Golf, Passat

IM211Ignition Module

Subaru Impreza

TP115Throttle Position Sensor

Nissan Dualis

GE520GENFuel Pump Module - GEN OEM

GE252GENElectric Fuel Pump - GEN OEM

Toyota Rav4, Tarago

Land Rover Discovery Series 2


Holden Commodore VE


Subaru Legacy, Liberty

ECMLIB2REPElectronic Control Module

Mazda RX-8

GE478GENFuel Pump Module - GEN OEM

GE416GENElectric Fuel Pump - GEN OEM

Mitsubishi Galant, Lancer Honda CRX EG, EJ

ECMCRXREPElectronic Control Module

Fiat Ducato

ABSBOS532REPABS Module

Lexus SC400 / Toyota Soarer

CLISC300REP Climate Control Module

Subaru Impreza, Legacy, Liberty


Porsche / VW Beetle

GIC686Ignition Coil (6 volt)

Alfa Romeo / Fiat

C651Ignition Coil

Mitsubishi Triton ML, MN

IAC606Idle Speed motor

ECM16C3REPElectronic Control Module

Suzuki Grand Vitara

BMW E30

DASE30REPDash Instrument Cluster

BMW E28, E24, E23

DASE28REPDash Instrument Cluster

*Repair service*Repair service

ECM16CP31REPElectronic Control Module

Mercedes Benz Sprinter, Viano, Vito

*Repair service *Repair service *Repair service *Repair service*Repair service

*Repair service

THE TRULY INDEPENDENT LEADER IN ENGINE MANAGEMENT AND

MECHATRONIC PRODUCTSim-group.com.au

MAR 2018

newsFRONT COVERBACK COVER

TECHNICALBULLETIN

Renault Clio, Megane

C649GENIgnition Coil - GEN OEM

Nissan Navara, Pathfinder

VS202GENTurbo boost control valve

HOLDEN COMMODORE VE / STATESMAN WM / CAPRICE WM SERIES - STOP LIGHTS NOT OPERATING DUE TO (BCM) BODY CONTROL MODULE FAILURE

This month’s featured product is a new genuine alternative Goss Fuel Pump Module to suit BMW E60/E61 5 series. Goss is well known in the Australian Automotive Aftermarket for its genuine quality direct replacement fuel pumps. All Goss fuel pumps are supplied with the correct strainer to do the right job first time.

The Goss brand is continually expanding its range of quality aftermarket fuel pumps, fuel pump modules, fuel tank sender units as well as ignition coils and rotation sensors.

Visit Goss.com.au

GE518 - BMW 5 E60 / E61 5 Series Fuel Pump Module

NOWAVAILABLE

FOLD

FOLD

Mercedes Benz W163

ESM04REPElectronic shift module

Hyundai i30 FD

ECMSIM2KREP Electronic control module

Porsche Cayenne, Panamera

C636Ignition Coil

Honda Accord / Odyssey

C638Ignition Coil

Audi Q7 / Porsche Cayenne (R/H/S)


Audi Q7 / Porsche Cayenne (L/H/S)


You can visit www.injectronics.com.au for more details or to book in a repair and to locate your nearest reseller.

Engine: 3.0L, 3.6L & 6.0L Year: 2006-2013

Body Control Module Part no #15921353

Injectronics’ technical support are regularly contacted by customers enquiring about the stop lights either not operating or staying illuminated on their Holden Commodore VE series or Statesman/Caprice WM series. In most cases this problem arises after the vehicle has been used for towing purposes. This may be caused due to overloading the circuit or a dead short.

As with many vehicles today the BCM controls the operation of the stop lights including the centre high mounted stop lamp. The BCM provides a 5-volt reference voltage & a low reference signal to the Brake Pedal Position Sensor (BPPS). When the brake is applied, the BPPS sends a signal proportional to the pedal travel to the BCM. The BCM supplies battery voltage to the stop lamps, ECM & TCM. The stop lamps will not operate unless the ignition is in the ON position.

Injectronics can test and repair these BCM’s for stop light failure avoiding the need to reprogram a brand new replacement unit saving time and money. The BCM on the affected vehicles is located on the RH side of the steering column and can be accessed by removing the steering column panel/fuse panel cover.

Prior to reinstalling the BCM customers are also advised to have the stop lights and associated wiring checked on the vehicle, as well as the trailer to avoid any further damage reoccurring.

*Repair service

*Repair service

*Repair service

GE518

BACK COVER FOLD FRONT COVER MAR 2018 TECHNICAL …

Documents

Transcript of BACK COVER FOLD FRONT COVER MAR 2018 TECHNICAL …