aw DD400 Setup Manual G03 140319 Manual...Drum Key Snare L - Metal Rod X 1 (Length:165mm) Tom&Module...
Transcript of aw DD400 Setup Manual G03 140319 Manual...Drum Key Snare L - Metal Rod X 1 (Length:165mm) Tom&Module...
1 Check the include items
Setup Guide
CYMBAL PADS BOX
Cymbal Pad for Hi-Hat Cymbal Pad for Crash
DRUM PADS BOX
ACCESSORIES BOX
STAND AND CYMBAL HOLDER BOX
Cymbal Holder x3 Drumsticks
Owner’s Manual Setup Guide
Hexagon Key
WARNING: Drum key can be pinched when adjusting clamps with drum key. Operate carefully. Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
AC Adaptor
Connection Cable X 9
Cymbal Pad for Ride
HI-HAT PEDAL BOX
DRUM MODULE BOX
Drum Key Snare L - Metal Rod X 1(Length:165mm)
Tom&Module L - Metal Rod X4(Length:110mm)
Tom Pad x3
BASS DRUM BOX
Bass Drum Pedal
Handscrew X 2
0
5
25
75
95
100
aw_DD400_Setup_Manual_G03_140319
2014 3 19 11:44:27
2
2
1
1
21
1
2
3
23
3
Attach the Parts
Attach the Pads
1. Loosen wing nut on the holder clamp, which is on the center pipe、 Side arm(L) and Side arm (R).
2. Insert the Snare L-Metal Rod into the holder clamp on the Side arm(L),then insert the Tom&Module L-Metal Rod into the holder clamp on the Center Pipe and Side Arm(R), tighten wing nuts on the holder clamp.
3. Attach drum pads to the Snare L-Metal Rod and the Tom&Module L-Metal Rods then tighten wing nuts , Repeat for each pad.
Attach the Cymbal Pads
1. Loosen wing nut on the holder clamp on pillar(L)、 、 pillar(R) and side arm(L).
2. Insert each cymbal holder into pillar(L)、 pillar(R)、side arm(L), and tighten wing nut.
3. Remove wing nut and felt washer from cymbal lilter.
4. Place cymbal pad on tilter assembly. Re-attach the felt washer and wing nut. Tighten wing nut.
2
3
4
0
5
25
75
95
100
aw_DD400_Setup_Manual_G03_140319
2014 3 19 11:44:30
3Attach the Drum Module
Connection Procedure
1.
2.
3.
Are you ready? Let's enjoy playing it.
Place the pedal on the floor on your left side.
Place the bass drum pedal on the floor in the center of rack.
Please connect the clearly marked cables from the pads to the correct inputs on the drum module.
Connect the Pads to the Drum Module
DD400_G03
1
4
2
3
Cymbal Pad
To Tom1 RideTo
To Crash
Drum Module
To Tom2
To Tom3
To Snare
Drum Pad
1 2
To HI-Hat
PedalHi-Hat
To Hi-Hat control To Kick
Bass Drum Pedal
1.
2. Insert the "L-Metal Rod" to the clamp
3. Insert the drum module to the L-Metal Rod
Tighten the wing screw on the clamp.
Loosen wing nut on the clamp ,
.
.
4.
wich is on the center pipe.
0
5
25
75
95
100
aw_DD400_Setup_Manual_G03_140319
2014 3 19 11:44:32