Automatic Watering System in Greenhouse
-
Upload
b-mishu -
Category
Engineering
-
view
114 -
download
0
Transcript of Automatic Watering System in Greenhouse
![Page 1: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/1.jpg)
Presentationon
Automatic Watering System In Greenhouse
International Islamic University ChittagongDepartment of Computer Science & Engineering
Prepared By:Abdur Rahman(C-151023)Minhajul Alam(C-1510001)Foyzul Abrar Chy(C-151063)M. Irfanul Kalam Chy(C-151110)Yamin Sobhan(C-151020)Ishrak Md. Imtiaz(C-151099)
Submitted To:Abdullahil KafiAssistant ProfessorDept. of CSE, IIUC
![Page 2: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/2.jpg)
Objectives
To reduce the cost of labor. Saving the time is the major purpose of this project. To save the plants from being rotten because of over
irrigation.
![Page 3: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/3.jpg)
Embedded System
A microcontroller or microprocessor based system that is built to control the functions of equipment, machinery or plant.
Combination of hardware and software for specific application.
![Page 4: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/4.jpg)
Apparatus
Hardware:• Moisture Sensor module• Arduino UNO• 12V Solenoid Valve• Adapter 12v• Resistor 1k ohm• Diode 1N4007• Transistor TIP122• Bread Board
Software:• Arduino IDE
![Page 5: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/5.jpg)
![Page 6: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/6.jpg)
How does it work:
We will set a fixed moisture level for three moisture sensors in the Arduino UNO.
The three moisture sensors will detect the moisture level from the soil.
When the detected level of moisture will exceed the given level in the Arduino UNO, then water supply through solenoid Valve will gonna be off.
Until then the water supply will go on.
![Page 7: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/7.jpg)
Moisture sensor
Arduino UNO
Solenoid Valve
Water Supply
Block Diagram:
![Page 8: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/8.jpg)
Arduino UNO:
Arduino Uno is a microcontroller. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button.
![Page 9: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/9.jpg)
Moisture Sensor:
This is a simple water sensor can be used to detect soil moisture when the soil moisture deficit module outputs a high level, and vice versa output low.
Operating voltage 3.3V-5V.
![Page 10: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/10.jpg)
Solenoid Valve:
The 12V solenoid controlled fluid valve. Simply connect a fluid source to the ¾" threaded inlet and it will interrupt the flow until 12V is applied to the fast-on connectors on the solenoid.
![Page 11: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/11.jpg)
Arduino Code:
![Page 12: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/12.jpg)
Green House:
![Page 13: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/13.jpg)
Project Pictures:
![Page 14: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/14.jpg)
Limitations of this Project:
We didn’t use a gravity-feed solenoid valve. This means that we will need
3 PSI water pressure to fully open the valve. As the moisture sensor can’t cover the whole field, the moisture value
may vary. Moisture Sensor does not give absolute reading of moisture, gives
relative.
![Page 15: Automatic Watering System in Greenhouse](https://reader033.fdocuments.us/reader033/viewer/2022051122/58a3f6721a28ab64528b4811/html5/thumbnails/15.jpg)
Thank You!