Assembling Cat5 Utp Cable - (Scppn Part 6)
-
Upload
roger-embalsado -
Category
Documents
-
view
273 -
download
2
description
Transcript of Assembling Cat5 Utp Cable - (Scppn Part 6)
Assembling CAT 5 UTP Cable
Step 1: Cut a Length of Cable
Be sure to measure the required length of the cable before cutting.
Step 2: Strip off the Jacket
• Use a wire stripper as shown.• A sharp knife or cutter may be
used but be careful not to “nick” the wires inside.
• Strip about 2.5 centimeters
Step 3: Separate the Wires
Step 4: Untwist the Wires
• Untwist the wires in a way such that it would be easy to arrange.
Step 5: Organize and Flatten Wires
Straighten the wires and arrange according to standard.
Step 6: Clip the Wires
Cut the wires evenly at the end.
Step 7: Insert Wires into RJ-45 Plug
• Insert the wires in the RJ-45 connector.
• Be careful not to disarrange the wire.
• The jacket must reach the point indicated by the arrow in the figure.
Step 8: Push the Wires In
Push the wires inside the connector until you see all the wire copper conductors.
Step 9: Inspect the Color Code
Note: Be sure the jacket reaches the point indicated above.
Step 10: Crimp Down the Wires
NOTE: Crimp firmly to secure electrical connection.
Step 11: Inspect Both Ends
Step 12: Test the Quality of Cable