ARD-P2634-01 - Proximity reader with keypad - Bosch...
2
Systems | ARD-P2634-01 - Proximity reader with keypad Functions Operation Modes The ARD-P2634-01 - HID is equipped with 2 electronically interlocked devices: The Proximity Reader and the Piezoelectric Keypad. ARD-P2634-01 - HID supports the following operation modes: 1. Prox-Pin: Present Prox card. The unit will read the content and send it over the Data wires to the host. Enter PIN code following by # key. The unit will send the PIN code over the same Data wires to the host. The Keypad and the Prox reader are interlocked so that when one is functioning the other is inhibited until the data is transmitted. 2. Prox-only: The prox electronics is independently communicating via Data wires. Verification Power up the unit. During the first 5 seconds it is possible to reprogram the Site code (see instructions) the unit will activate the buzzer and the Yellow LED 3 times. In the same time the RED or the Green LED will be ON for the first 5 seconds. Present a valid HID encrypted card at 5 cm distance maximum. The unit will activate the Buzzer and the Yellow LED once. Enter any combination of PIN code up to 65534 followed by #. The unit will activate the Buzzer and the Yellow LED once. Wiegand Specification When the LED control input is pulled low, the GREEN LED will be ON and the RED LED will be OFF. When the input goes high the RED LED is ON and the GREEN LED is OFF. The RED or GREEN LED will flash with each key press. The LED control input is pulled to the internal +5V with a 2.2K resistor. The data is sent at 2 milliseconds per bit with a pulse duration of 70 μsec. A Buzzer beeps with each key press. Installation/Configuration Notes Preparing and Mounting • Remove the backplate from the reader • Fix the backplate at the wall • Put the cable into the cable hole • Fix the reader with 4 screws • Fix the backplate with a screw Note Special screwdrivers are necessary. ARD-P2634-01 - Proximity reader with keypad ▶ Proximity reader with keypad ▶ Ruggedised version ▶ Output keypad 26 bit Wiegand www.boschsecurity.com
Transcript of ARD-P2634-01 - Proximity reader with keypad - Bosch...
Systems | ARD-P2634-01 - Proximity reader with keypad
Functions
Operation Modes
The ARD-P2634-01 - HID is equipped with 2 electronicallyinterlocked devices: The Proximity Reader and thePiezoelectric Keypad.
ARD-P2634-01 - HID supports the following operationmodes:
1. Prox-Pin:Present Prox card. The unit will read the content andsend it over the Data wires to the host. Enter PIN codefollowing by # key. The unit will send the PIN code overthe same Data wires to the host. The Keypad and theProx reader are interlocked so that when one isfunctioning the other is inhibited until the data istransmitted.
2. Prox-only: The prox electronics is independently communicatingvia Data wires.
Verification
Power up the unit. During the first 5 seconds it is possibleto reprogram the Site code (see instructions) the unit willactivate the buzzer and the Yellow LED 3 times. In the sametime the RED or the Green LED will be ON for the first 5seconds.
Present a valid HID encrypted card at 5 cm distancemaximum. The unit will activate the Buzzer and the YellowLED once.
Enter any combination of PIN code up to 65534 followedby #. The unit will activate the Buzzer and the Yellow LEDonce.
Wiegand Specification
When the LED control input is pulled low, the GREEN LEDwill be ON and the RED LED will be OFF. When the inputgoes high the RED LED is ON and the GREEN LED is OFF.The RED or GREEN LED will flash with each key press. TheLED control input is pulled to the internal +5V with a 2.2Kresistor.
The data is sent at 2 milliseconds per bit with a pulseduration of 70 μsec. A Buzzer beeps with each key press.
Installation/Configuration Notes
Preparing and Mounting
• Remove the backplate from the reader• Fix the backplate at the wall• Put the cable into the cable hole• Fix the reader with 4 screws• Fix the backplate with a screw
Note Special screwdrivers are necessary.
ARD-P2634-01 - Proximity reader withkeypad
▶ Proximity reader with keypad
▶ Ruggedised version
▶ Output keypad 26 bit Wiegand
www.boschsecurity.com
2 | ARD-P2634-01 - Proximity reader with keypad
Wiring
COLOR FUNCTION ELECTRICAL FUNCTION
RED Input Voltage 12 to 24 VDC
BLACK Ground
GREEN Data 0 Open collector 1KOhm pull-up to inter-nal +5V
WHITE Data 1 Open collector 1KOhm pull-up to inter-nal +5V
BROWN LED input No voltage
BLUE CCTV output Open collector 0,1 A activated witheach key for 30 sec.
VIOLET Housing ground
ORANGE Buffered input
GREY Tamper output Open collector 0,100 A “Low” whenlight sensed.
Technical Specifications
Output Formats:Prox. CardKeypad
-Wiegand 26Wiegand 26
The Prox. Card Output is customizable for other Wiegand formats.
Power Supply 12 to 24 VDC
Power Consumption max. 150 mA
Transmitter/Receiver Frequency 125 Khz
Mounting Universal USA and Europe
Environment IP68; 100% relative humidity
Operating Temperature -30 to +65 °C (-22 to 150 °F)
Dimensions 120 x 90 x 20 mm(4.72 / 3.54 / 0.79 in.)
Antitamper optical protection
Ordering Information
ARD-P2634-01 - Proximity reader withkeypadRugged reader (Prox – 125 KHz) with piezo-electric keypad, beeper and LED displays. Out-put formats: 26 Bit card and keypad
ARD-P2634-01
Americas:Bosch Security Systems, Inc.130 Perinton ParkwayFairport, New York, 14450, USAPhone: +1 800 289 0096Fax: +1 585 223 [email protected]
Europe, Middle East, Africa:Bosch Security Systems B.V.P.O. Box 800025600 JB Eindhoven, The NetherlandsPhone: + 31 40 2577 284Fax: +31 40 2577 [email protected]
Asia-Pacific:Robert Bosch (SEA) Pte Ltd, Security Systems11 Bishan Street 21Singapore 573943Phone: +65 6258 5511Fax: +65 6571 [email protected]
Represented by
© Bosch Security Systems Inc. 2010 | Data subject to change without noticeT3664092427 | Cur: en-US, V7, 4 Jul 2010
