ApogeeConnnects - Apogee Electronics
1
Apogee ApogeeConnnects : MiniMe - MiniDac - Digidesign MBox Hardware Connections Mic Input (WE-XX-5.0) Analog Outs (WE-XX-5.0) Hardware Settings Set for desired gain Set for desired sample rate (up to 48kHz) S/PDIF CX Software Settings After making all the hardware connections, open Pro Tools software. Under Setups select Hardware Setup. In the Hardware Setup page, set Clock Source to S/PDIF, and set Ch. 1-2 Input Source to S/PDIF. As configured above, Pro Tools software inputs are routed from the Mini-Me’s hardware inputs, and Pro Tools software ouputs are routed to both the MiniDAC’s and MBox’s hardware outputs. Also, note that the MiniMe’s DIR-USB and MON knobs are not used. S/PDIF WE-RR-1.0 S/PDIF WE-RR-1.0
Transcript of ApogeeConnnects - Apogee Electronics
ApogeeApogeeConnnects : MiniMe - MiniDac - Digidesign MBox
Hardware Connections
Mic Input(WE-XX-5.0)
Analog Outs(WE-XX-5.0)
Hardware Settings
Set fordesired gain
Set for desired sample rate(up to 48kHz)
S/PDIF CXSoftware Settings
After making all the hardware connections, open Pro Tools software. Under Setups select Hardware Setup.In the Hardware Setup page, set Clock Source to S/PDIF, and set Ch. 1-2 Input Source to S/PDIF.As configured above, Pro Tools software inputs are routedfrom the Mini-Me’s hardware inputs, and Pro Tools software ouputs are routed to both the MiniDAC’s and MBox’s hardware outputs. Also, note that the MiniMe’s DIR-USBand MON knobs are not used.
S/PDIF WE-RR-1.0
S/PDIF WE-RR-1.0