Anterior vitrectomy

26
م ي ح ر ل ا ن م ح ر ل ه ا ل ل م ا س ب م ي ح ر ل ا ن م ح ر ل ه ا ل ل م ا س ب

Transcript of Anterior vitrectomy

Page 1: Anterior vitrectomy

الرحمن الله الرحمن بسم الله بسمالرحيمالرحيم

Page 2: Anterior vitrectomy

Anterior VitrectomyAnterior Vitrectomy

· Mohamed Zaki (M.Sc) · Tanta University

Page 3: Anterior vitrectomy

Aim· Prevent intra/post-operative vitreous

traction

· Leave a clean anterior segment

· IOL implantation

Page 4: Anterior vitrectomy

Event

· * PCT

· * Zonular dialysis

Page 5: Anterior vitrectomy

1- Once you suspect

Keep irrigation till inject methyl

Vitreous flow from high to low pressure

Page 6: Anterior vitrectomy

2- Keep the AC formed

The anterior vitrectomy should be done through tight paracentesis (not the main wound)

Make new paracentesis to fit bare vitrector shaft using original side-port

for irrigation

Page 7: Anterior vitrectomy

3- Don’t sweep vitreous from the wound

Traction on the anterior vitreous is dangerous because of the strong, permanent vitreoretinal adherence at the vitreous base

Page 8: Anterior vitrectomy

· The vitreous cutter should be used to amputate any posterior connection to wound entrapped vitreous.

· OVD can be used to reposit vitreous through the incision

Page 9: Anterior vitrectomy

4- Adjust machine parameters

· High cutting rate

· Lowest effective flow and vacuum

· Irrigation → cut → aspiration

Page 10: Anterior vitrectomy

Irrigation Cutting Vacuum

Anterior vitrectomy

Low bottle hight

(to maintain normotension)

High600 - 2500 /

min

Low (150 – 250 mm Hg)

Lensectomy Low 300 / min

Page 11: Anterior vitrectomy
Page 12: Anterior vitrectomy

5- Technique

1. The irrigation is placed in the AC directed towards the AC angle

2. The vitrector is placed through the capsular tear directed to the optic nerve with the aspiration port facing up .

3. The cutter should be maintained in a central position and not moved peripherally to avoid stress on the vitreous base.

4. The vitreous is removed to a level just posterior to the capsule

Page 13: Anterior vitrectomy

5 -the cutter is moved forward into the capsular bag. The remaining lens matter is removed with the cutter, reducing the cut rate to 300 cuts/min and increasing vacuum.

6- The cortex is then engaged, using the

vacuum-only setting of the cutter, and stripped off the capsule..

Page 14: Anterior vitrectomy

· The cutter should be held stationary while suction is applied to reduce traction;

· The cutter tip should always be in view when activated.

Page 15: Anterior vitrectomy

video

Page 16: Anterior vitrectomy

End point : no vitreous in the AC & no vitreous in the bag

· * rounded pupil· * Clean incision· * Sweep infusion canula from angle to

angle· *Instill air or triamcinolone and rinse

away.

Page 17: Anterior vitrectomy
Page 18: Anterior vitrectomy

TAAC

· Diluted 1 : 10

· Should be completely removed by end of case ( IOP )

Page 19: Anterior vitrectomy
Page 20: Anterior vitrectomy

Types of anterior vitrectomy

Bi manual

Coaxial

Dry ( small amount of vitreous)

Parsplana anterior vitrectomy

(single pars plana port )

Page 21: Anterior vitrectomy

Coaxial

· Easy but may increase the tear· Irrigation is directed to the vitreous

lead to more prolapse.

Page 22: Anterior vitrectomy

Pars plana Anterior vitrectomy

· More efficent particularly in extensive prolapse

· Used also in traumatic lens sublaxation or angle closure glaucoma.

· Cutter should be visualized , surgeon should be familial with the technique

Page 23: Anterior vitrectomy
Page 24: Anterior vitrectomy

Residual cortex

· After completeing anterior vitrectomy

· Dry technique

· Or : with the vitrectomy cutter set to :· I / A / cut

Page 25: Anterior vitrectomy

Conclusion

• Maintain a closed chamber• Separate the infusion from the cutter • Use a low bottle height • Use a high cut rate • Use low to moderate aspiration • Identify any vitreous remaining with

triamcinolone stain • Preserve the capsule

Page 26: Anterior vitrectomy