An Approach to Predict Blank Shape for Auto-Position in Multistage Sheet Metal Forming
-
Upload
jiang-chen -
Category
Documents
-
view
13 -
download
0
Transcript of An Approach to Predict Blank Shape for Auto-Position in Multistage Sheet Metal Forming
An approach to predict blank shape for auto-position in multistage sheet metal forming
Jiang Chen, Wenliang Chen, and Guokang Du
Citation: AIP Conference Proceedings 1567, 1028 (2013); doi: 10.1063/1.4850146
View online: http://dx.doi.org/10.1063/1.4850146
View Table of Contents: http://scitation.aip.org/content/aip/proceeding/aipcp/1567?ver=pdfcov
Published by the AIP Publishing
This article is copyrighted as indicated in the article. Reuse of AIP content is subject to the terms at: http://scitation.aip.org/termsconditions. Downloaded to IP:
128.184.184.37 On: Wed, 15 Jan 2014 06:53:58
This article is copyrighted as indicated in the article. Reuse of AIP content is subject to the terms at: http://scitation.aip.org/termsconditions. Downloaded to IP:
128.184.184.37 On: Wed, 15 Jan 2014 06:53:58
This article is copyrighted as indicated in the article. Reuse of AIP content is subject to the terms at: http://scitation.aip.org/termsconditions. Downloaded to IP:
128.184.184.37 On: Wed, 15 Jan 2014 06:53:58
This article is copyrighted as indicated in the article. Reuse of AIP content is subject to the terms at: http://scitation.aip.org/termsconditions. Downloaded to IP:
128.184.184.37 On: Wed, 15 Jan 2014 06:53:58