AMK Compressor Rebuild Kit

Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK

compressor has been built very specifically

risk of the piston cracking in this repair aswell as damage to the electrical components. Great care

must be taken when taking apart this compressor.

are prepared to replace the entire unit incase you damage it.

1. Begin with removing the 8 torx bolts that hole the electrical cover and dryer unit

7 bolts can be seen below.

The dryer unit will pull up but depending on how seized the electrical cover is with

need tapping off.

Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK

specifically so that it is very difficult for an owner to repair.

risk of the piston cracking in this repair aswell as damage to the electrical components. Great care

must be taken when taking apart this compressor. Please do not repair this compressor unless you

are prepared to replace the entire unit incase you damage it.

torx bolts that hole the electrical cover and dryer unit

will pull up but depending on how seized the electrical cover is with

Please note that this is not an easy repair like our Hitachi and Wabco repair kits. The AMK

for an owner to repair. There is

risk of the piston cracking in this repair aswell as damage to the electrical components. Great care

Please do not repair this compressor unless you

torx bolts that hole the electrical cover and dryer unit and piston cover.

will pull up but depending on how seized the electrical cover is with corrosion it may

Remove the allen bolt so that you have access to the other side of the electrical

pressed out.

Remove the allen bolt so that you have access to the other side of the electrical unit so that it can be unit so that it can be

To push the electrical unit out will require either a press

you let this soak in PB Blaster or Plus Gas overni

piston. It's best to soak it, hammer it and then follow up with a press.

Once the unit presses out you will be able to pull out the piston. Proceed to remove the

on the piston cap, these can sometimes snap so we have included a replacement cap and screws just

incase! Replace all 4 seals on the seal. The flat

your finger to gain it's shape and fit them on, they are very flexible.

To push the electrical unit out will require either a press or some hammering. We highly recommend

you let this soak in PB Blaster or Plus Gas overnight as sometimes the bearing can seize onto the

piston. It's best to soak it, hammer it and then follow up with a press.

you will be able to pull out the piston. Proceed to remove the

on the piston cap, these can sometimes snap so we have included a replacement cap and screws just

4 seals on the seal. The flat seals arrive flat so you will need to wrap them around

gain it's shape and fit them on, they are very flexible.

ring. We highly recommend

s sometimes the bearing can seize onto the

you will be able to pull out the piston. Proceed to remove the 3 torx bolts

on the piston cap, these can sometimes snap so we have included a replacement cap and screws just

you will need to wrap them around

Push the piston back in, when it gets to the top seal

the seal so it is ready to have the electrical unit pressed back in.

Once the unit is pressed put the cap back on,, watch out for the bushes, they will need pushing back

inwards as you push the cover on.

when it gets to the top seal you can slap it in to get it past the ridge. Line up

the seal so it is ready to have the electrical unit pressed back in.

is pressed put the cap back on,, watch out for the bushes, they will need pushing back

inwards as you push the cover on.

you can slap it in to get it past the ridge. Line up

is pressed put the cap back on,, watch out for the bushes, they will need pushing back

Replace the final o-rings and fit the compressor back together and the repair has been completed.