Amazon Fire TV Power Cord Port Replacement Guides... · To reassemble your device, follow these...

5
Amazon Fire TV Power Cord Port Replacement Power cord port replacement. Written By: jeffrey555 Amazon Fire TV Power Cord Port Replacement © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

Transcript of Amazon Fire TV Power Cord Port Replacement Guides... · To reassemble your device, follow these...

  • Amazon Fire TV Power Cord Port ReplacementPower cord port replacement.

    Written By: jeffrey555

    Amazon Fire TV Power Cord Port Replacement

    © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

  • INTRODUCTION

    If your device is not working due to a faulty power cord, you can follow this guide to easily replacethe faulty cord with a new one.

    TOOLS:iFixit Opening Tools (1)

    Soldering Workstation (1)

    JIS Driver Set (1)

    Amazon Fire TV Power Cord Port Replacement

    © iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

    https://www.ifixit.com/Store/Parts/iFixit-Opening-Tool/IF145-335-2http://www.ifixit.com/Tools/Soldering-Workstation/IF145-238http:/IF145-115-1

  • Step 1 — Motherboard

    Place the plastic opening tool in the space between the rubber and the plastic case of the device.

    Apply pressure by pushing upward on the case.

    Separate the bottom square rubber piece from the case using the plastic opening tool until all clipsare detached.

    Step 2

    Locate the ten J#00 Phillips screws and remove them.

    Amazon Fire TV Power Cord Port Replacement

    © iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

  • Step 3

    Place your finger on the short edge of the motherboard and lift it to separate it from the plasticcase.

    Step 4 — Power Cord Port

    With the mother board back facing you locate the power cord port found on the far left end.

    Amazon Fire TV Power Cord Port Replacement

    © iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

  • To reassemble your device, follow these instructions in reverse order.

    This document was last generated on 2017-06-24 01:57:41 AM.

    Step 5

    Locate the four soldering joints for the power cord port found on the top side of the mother board.

    Desolder the joints of the power cord port to release it from the motherboard.

    Place the new power cord port into its original location and solder its joints.

    Use the iFixit soldering and desoldering guide.

    Amazon Fire TV Power Cord Port Replacement

    © iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5

    https://www.ifixit.com/Guide/How+To+Solder+and+Desolder+Connections/750

    Amazon Fire TV Power Cord Port ReplacementWritten By: jeffrey555INTRODUCTION

    TOOLS:Step 1 — MotherboardStep 2Step 3Step 4 — Power Cord PortStep 5