Alexis Large Sideboard - dunelm.com · Alexis Large Sideboard White High Gloss PVC H72xW155xD42cm ....
Transcript of Alexis Large Sideboard - dunelm.com · Alexis Large Sideboard White High Gloss PVC H72xW155xD42cm ....
Alexis Large SideboardWhite High Gloss PVCH72xW155xD42cm
Thank you for purchasing your new piece of furniture from Dunelm.
We put a lot of effort in the design and construction of our products to ensure they set the standard for quality, durability and ease of assembly.
If for any reason you feel we haven’t lived up to the high standards we set ourselves, please don’t hesitate in contacting us on 03451 656565 where our team will be very keen to understand what has gone wrong and, more importantly, put it right.
The Next Step...
straight forward, step-by-step guide to make sure that assembling your furniture is as easy as 1, 2, 3.
Before you begin, we advise that you check that you have everything you need to get started.
DEAR CUSTOMER
TOP TIP
Lay each panel down on a clean and level area, ideally in the room of intended use, ensuring there is enough room to manoeuvre around the item. It is recommended that two people assemble thisproduct together.
TOP TIP
component, to make things easier when you are putting it all together.
on page 3 and 4 of this manual.
Safety and Care Advice
IMPORTANT - Please take the time to read and understand these instructions before assembling your furniture.Please keep these instructions for future reference.
Keep children and animals away from the assembly area.This furniture contains small parts that could cause choking if swallowed.Keep all plastic wrapping materials away from babies and children to avoid danger of suffocation.Ensure that all packaging is disposed of carefully and responsibly.
Two people may be required for the assembly of this product.Once items are part or fully assembled they are not returnable unless faulty.This item is not for outdoor use – unless stated otherwise.
to the wall, to prevent a child from accidentally pulling furniture over.Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a competentperson. No liability will be accepted for damage or injury caused by incorrectly installed orassembled furniture.
1
Parts & Fittings for the
Panel-exploded view
Alexis Large Sideboard(30477969)
2
1
2
4
5
3
6
6
7
8
9
9
10
10
11
11
12
12
1314
15
16
Panels-plan view
1 Top x1420x1550mm
3
2 Left side x1419x518mm
Right side x1419x518mm
53 Left Middle divider x1
388x518mm
L/R Back x2493x526mm
6Base x1420x1550mm
8
Metal Bar x225x1300mm
9 Metal Leg x2160x383mm
10
L/R Adjustable Shelf x2369x483mm
12 Right Door x1498x510mm
14
Left Door x1498x510mm
16
4 Right Middle divider x1388x518mm
Middle Back x1504x526mm
7
Adjustable Leg x238x160mm
11
Middle Adjustable shelf x1369x502mm
13
Middle Door x1498x510mm
15
Fittings
12mmBA
Ø8x30mmC
HF
D
K
Ø4mm
Ø6x50mm
Ø4x16mm
L
Ø3x14mm
O
4
Cam lock x8 Cam bolt x8 Wooden Dowel x8
Back wedge x9screw x4
screw x8
Allen Key x1 Anti-tip Kit x2screw x6
35mm
Tools requiredCross slot screwdriver Hammer Tape measure
The use of power tools to assemble the product is not recommended due to the risk ofover tightening fixings.
Before you startCheck the pack and make sure you have all the parts listed above. If not ,contact thehelpline on 03451 656565 who will be able to help you.When you are ready and sure that you have the right tools to hand,you will need plentyof space and a clean dry area for assembly.
G
Ø5x16mmShelf support x12
I
8mmscrew x3
J
Ø6x12mmscrew x4
M
Ø4.5x15mmscrew x36 Magnetic catch x3
Hinge x6
E
Ø6x38mmHandle screw x8
N
P Q
Ø25mm Cover x8
Ready?Follow this step-by-step guide
5
B
Note:Insert cam bolt asshown
1
Rear edge
1
2
B
B
B
B
B
B
B
B
1
Rear edge
Ensure the cam is pressed fullyinto the hole and arrow pointingtowards the short edges
2
A
C
10mm
A A
Cam lock in open position
Cam lock in closed position
2
Rear edge
A
A
C
C
5
A
A
C
C
6
3
4
A
A
C
C
3
A
A
C
C
4
2
5
A
1
Rear edge
4
3
7
5
6
6
7
Front edge
6
K
Front edge
8
D
D
D
DD
D
D
D
8
7
8
9
9
10
10
J
J
J
J
K 10
9
9
10
Front edge
EE
E
EE
EE
E
9
10
9
K
Ensure all screws are well insert before fasten
Two people required to turn unit over
Front edge
11
11
10
11
12
Front edge
12
13
Ensure the finished surface isfacing the outside
11
13
14
MM
MM
P
P
I
15
16
I
MM
MM
P
P
MM
P
15I
16
MM
MM
P
P
I
14
15
16
Adjust the hinge to ensure thegrain of wave panel on the same level
Adjust Hinge Position
15
16
12
Rear edge
H
H
H
HH
H H
H
H
Remove the plastic film onall panels after assembly.
Front edge
Rear edge
Important note:It is essential that this product is fixedto a wall using the plastic zip ties supplied.Wall fixing is not supplied.
13
Nearly there!17
FO
14
Wall Fixings
dunelm.com
Wall FixingsFollow this step-by-step guide
IMPORTANT:When drilling into walls always check there are no hidden wires or pipes etc. Make sure that the screws and wall plugs being used are suitable for supporting your unit. Consult a quali ed tradespersonif you are unsure.
HINTS1. General Rule; Always use a larger screw and wall plug if you are not sure.2. Ensure you use the recommended drill bit to match the wall plug and hole size.3. Ensure you drill the hole horizontally, do not force the drill or enlarge the hole.4. Take extra care when drilling high walls, ceilings and ceramic tiles. Ensure the plug is tting below the ceramic title to avoid splitting or cracking.5. Ensure wall plugs are well tted and are a tight t in the drilled hole.
Types of WallsYou can use one of thefollowing types of wall plug if your walls are made of brick, breeze block, concrete, stone, wood or plastic board.
1. STANDARD Wall Plug General wall materials
2. GENERAL PURPOSE Wall Plug Aerated/Breeze block
3. SHIELD ANCHOR Wall Plug Heavy loads
6. HAMMER FIXING Wall Plug
4. CAVITY FIXING Wall Plug
5. CAVITY FIXING HEAVY DUTY Wall Plug
These come in various sizes and are made from plastic or sometimes wood bre.
Generally aerated blocks should not be used to support heavy loads, use a specialist tting in this case. For light
loads, a General Purpose Plug can be used.
For use with heavier loads such
Satellite Dishes etc.
For use with walls stuck with plaster board. The hammer xing allows it to be xed to
the wall rather than the plaster board. Always check the xing is secure to the retaining wall.
For use with plaster boardpartitions or hollowwooden doors.
For use with plaster boardpartitions or hollowwooden doors.
CARE & MAINTENANCE
SafetyAlways check the fitting andlocation to ensure your safetyin and around the home.
FittingFrom time to time check the fitting to ensure the wall plugsor screws do not become loose.
.15
Finally, we hope you enjoy your furniture formany years to come and thanks againfor your purchase.
dunelm.com
Care and maintenanceOnly clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
From time to time check that there are no loose screws on this unit.
This product should not be discarded with household waste. Take to your local authority wastedisposal centre.
.16