Albeo LED Luminaire - Current by GE · GE LED Indoor Lighting Fixtures Subject: Discover how the...
Transcript of Albeo LED Luminaire - Current by GE · GE LED Indoor Lighting Fixtures Subject: Discover how the...
The Albeo™ ALC4-series LED luminaire is an energy-efficient, low maintenance alternative to traditional linear fluorescent in a variety of commercial, low bay lighting applications. Compact and sleek in design, the ALC4 features a long rated life of 77,000 hours (L70) and can deliver up to 600 feet of outstanding quality light in a continuous run configuration. Ideal for industrial, commercial and light assembly applications, the Albeo ALC4 LED fixture can be matched with motion, daylight and wireless controls for increased energy savings.
Product Features
Industry Awards
Applications
• Designed to meet recommended luminance and illuminance requirements for low bay and task level applications in commercial, industrial, warehouse, office, education, health, retail and data center settings.
• Recommended for low bay lighting applications at 20 feet or lower.
Housing
• Rugged extruded aluminum housing. • Each LED module is equipped with an upper limit thermal control to ensure fixture lifetime throughout the temperature range.
LED & Optical Assembly
• Precision lens system provides optimized illumination for open floor plan and aisle layouts.• Multiple photometric distributions of 20, 40, 80 and 120 degrees. Plus diffuse and wide lens options.• Utilizes high brightness LEDs, 70, 80 and 90 CRI at 4000K & 5000K typical. • LM-79, LM-80 tests and reports are performed in accordance to IESNA standards.• Directional LEDs put light where it’s needed without reflectors to greatly increase efficiency.
Lumen Maintenance
• System rating is L85 at 50,000 hours. Contact manufacturer for Lxx rating (Lumen Depreciation) beyond 50,000 hours.
Ratings
• DLC. Listed.• UL 1598 Suitable for Damp Locations.• UL 8750 LED equipment in Lighting Products.• Temperature Rated at (–30°C to 45°C) (-22°F to 113°F).• Projected L70 (15K) > 77,000 Life Hours per IES TM-21.
Mounting
• Chain, cable, 1/2” threaded rod, and surface mount.• Continuous run option available.
Finish
• White polyester powder coat.
Controls
• Motion and Daylight sensor can be combined for additional energy savings.• For wireless controls please consult factory.
Electrical
• 120-277 volt and 347-480 volt available. • System power factor is >90% and THD <20%.*• Integral surge protection: For 120-277VAC per IEEE/ANSI C62 41.1:1991, 4kV IEC 61000-4-12.• EMI: Title 47 CFR 15 Class A. * System power factor and THD is tested and specified at 120V input and maximum load conditions.
Warranty
• 5-year limited system warranty standard.
/
®
=
A L C 4 1 W _ _ _ _ - _ - _ - _ - _ _ - _ - _ - _ - _ - _ - _ _ - _ - _ - _ -
PRODUCTID VOLTAGE MODULE
1 = 1 module 1 = 120°2 = 20° 4 = 40° 8 = 80°
D = Diffused lens
W = Wide lens
4 = 4ft8 = 8ft
S = Both EndsL = LeftR = RightM = Open
End Cap Configura-tions can be found on Page 3 of this brochure.
N = NoneV = 0-10V Stand alone
D = 0-10V Daisy chain
R = Continuous run wiring
W = WhitePowder coat
Note: IES files located on GE websitewww.gelightingsolutions.com
*W = Wireless
*Please consult factory for wireless application
ST = StandardFits chain, cable and ½” threaded rod.
51 = Cable/ Hook 5 ft. pair52 = Cable/ Hook 10 ft. pair53 = Cable/ Hook 15 ft. pair54 = Cable/ Hook 20 ft. pair
SM = Surface Mount*
*Not available with continuous run
See Mounting & Accessories
0 = 120/2771 = 120* 4 = 277*5 = 480*D = 347*
*Specify single voltage only if cord and plug needed.
70 Plus CRI
47 = 4000K57 = 5000K
80 Plus CRI
48 = 4000K58 = 5000K
90 Plus CRI
49 = 4000K59 = 5000K
FINISH OPTIONSMOUNTINGMOTION/DAYLIGHT
SENSOR
K = Knock out access plugA = 6 ft. 18-3 cord & twist lock 15 amp plugB = 6 ft. 18-3 cord onlyC = 12 ft. 18-3 cord & twist lock 15 amp plugD = 12 ft. 18-3 cord only
See factory for custom cord lengths.
STAND ALONE FIXTURESN = NoneA = On/off motion aisleB = On/off motion 360C = On/off cold temp aisleD = On/off cold temp 360
If you choose options below you must choose control wiring option V or D
E = Daylight sensorF = Motion aisle/daylightG = Motion 360/daylightH = Pre-wired (no sensor)J = 0-10V Motion 360K = 0-10V Motion aisleL = 0-10V Motion 360 coldM = 0-10V Motion aisle cold
CONTINUOUS RUN FIXTURESN = NoneP = On/off motion 360Q = On/off cold temp 360R = Motion 360/daylightT = 0-10V Motion 360U = 0-10V Motion 360 cold
Note: Only 1 sensor needed for every 48 feet.
LED COLOR TEMP
OPTICSBEAM
FIXTURELENGTHS
ENDCAP
CONTROL WIRING
CORD &PLUG
DRIVECURRENT
A = Albeo
L = Linear
C = C-Series
4 = LED Generation
T = Standard
H = High Output
V = Very High Output
Ordering Number LogicAlbeo™ Linear Low Bay LED Lighting
1 T 4ft 72 3200 30 37 107 86 1 H 4ft 144 5350 47 52 114 103 1 V 4ft 144 7400 71 76 104 97 1 T 8ft 144 6400 57 69 112 93 1 H 8ft 288 10700 94 103 114 104 1 V 8ft 288 14800 142 152 104 97
MODULE#
DRIVECURRENT
FIXTURELENGTH 4000K/5000K 120-277V
WATTS LPW
347-480V 120-277V 347-480VLED
COUNT
TYPICAL INITIAL LUMENS 70 CRI
1 T 4ft 72 2700 30 37 90 73 1 H 4ft 144 4500 47 52 96 87 1 V 4ft 144 6200 71 76 87 82 1 T 8ft 144 5400 57 69 95 78 1 H 8ft 288 9000 94 103 96 87 1 V 8ft 288 12400 142 152 87 82
MODULE#
DRIVECURRENT
FIXTURELENGTH 4000K/5000K 120-277V
WATTS LPW
347-480V 120-277V 347-480VLED
COUNT
TYPICAL INITIAL LUMENS 80 CRI
120 (1) 100% 20 (2) 94% 40 (4) 92% 80 (8) 97% Diffused (D) 87% Wide (W) 97%
OPTICSBEAM
%OUTPUT
1 T 4ft 72 2350 30 37 78 64 1 H 4ft 144 3900 47 52 83 75 1 V 4ft 144 5350 71 76 75 70 1 T 8ft 144 4700 57 69 82 68 1 H 8ft 288 7800 94 103 83 76 1 V 8ft 288 10700 142 152 75 70
MODULE#
DRIVECURRENT
FIXTURELENGTH 4000K/5000K 120-277V
WATTS LPW
347-480V 120-277V 347-480VLED
COUNT
TYPICAL INITIAL LUMENS 90 CRI
Note: Lumen data shown is for 120 deg (1) optic. See tabel at right for other light optic factors.
End Cap ConfigurationSee page 2 for complete ordering number logic
S =Stand Alone
FixtureBoth End Caps
Left Right
ContinuousRun Fixture
Left End Cap
ContinuousRun FixtureRight End Cap
ContinuousRun FixtureOpen End Caps
(Middle)
L =
R =
M =
PhotometricsOptics for Common Applications
Aisle Distribution 20° Full Beam Angle
Narrow Distribution 40° Full Beam Angle
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
Spacing Criteria:Spacing CriteS g r0° = 1.880° = 10 .890° = 0.5690 56=
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
Spacing Criteria:Spacing CriteS g r0° = 1.490° = 10 .490° = 0.6690 66=
Standard Distribution80° Full Beam Angle
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
g Criteria:g CriteSpacingSpacingS g r0° = 1.280° = 10 .2
= 1.393990° =90 =
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
Spacing Criteria:Spacing CriteS g r0° = 1.320° = 10 .390° = 1.2890 28= 99
Standard Distribution120° Full Beam Angle
120° Diffused
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
Spacing Criteria:Spacing CriteS g r0° = 1.210° = 10 .290° = 1.3090 30= 9
VA: 0° 10° 20° 30° 40°
90°
80°
70°
60°
50°
Spacing Criteria:Spacing CriteS g rSpaci0° = 1.300° = 10 .3= 1.90° = 2.2790 27= 2.27
160° Wide Beam Angle
Lens selection by applicationThe Albeo™ ALC4-series optical lens system enables LEDs to provide precise illumination where needed. Lenses are designed for commercial & industrial applications where mounting height, fixture spacing & light levels help determine lens selection. The following table outlines lens options and suggested application. Consult factory for specific project layouts.
LENS TYPE MOUNTING HEIGHT SPACE TYPE
80°, 120°, Diffused, Wide Beam Below 20 Feet Open Floor Plan
20°, 40° Below 20 Feet Low Bay Aisles
Mounting & Accessories
MOUNTING OPTIONS IMAGE ORDER LOGIC CODE
Standard Chain/Cable/Rod MountAvailable on all fixture configurations(chain, cable or rod not included). Cable Hook can be ordered as an accessory.
Option ASurface Mount (optional)Not available with continuous run.
Option BSurface Mount (optional)Not available with continuous run.
ST = Standard
SM = Surface Mount
Chain/Cable/Rod Mount
Cable Hook (optional)Use with Standard cable/chain/rod mount.Order separately. Price adder per pair.5 ft., 10 ft., 15 ft., 20 ft. lengths available.
Chain/Cable/Rod mount is standard and included in price. Additional price for Cable Hook. See “Installation Instructions” for mounting details.
ALC4 can be mounted to a surface using holes predrilled in the bottom fixture or to a junction box using the mounting plate provided. See “Installation Instructions” for more details.
51=Cable-Hook-05ft-Pair52=Cable-Hook-10ft-Pair53=Cable-Hook-15ft-Pair54=Cable-Hook-20ft-Pair
96”
14.12”
2.57”
4.72”
14.12”
2.57”
4.72”
Product DimensionsAlbeo™ Linear Low Bay LED Lighting
(ALC4 - 4 ft./8 ft.)
48”
2.43”
2.43”
4.80”3.87”
End View
End View
48”
2.43”
Top View
Top View
Wireless Control/Occupancy Sensor Module
48”
2.43”
Side View
Side View
Weight: 2.5 lbs.Note: The occupancy sensor shown is a representative example
96”
Weight:120-277V: 8 lbs.347/480V: 11 Lbs.
Weight:120-277V: 16 lbs.347/480V: 19 Lbs.
www.gelighting.comGE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property of their respective owners. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions. GE Lighting and GE Lighting Solutions, LLC are businesses of the General Electric Company. © 2014 GE.
ALB004 (Rev 09/15/14)