Airport Markings and Lighting
Transcript of Airport Markings and Lighting
Virginia Tech
1 of 31
Airport Markings and Lighting
Dr. A. A. TraniAssociate Professor of Civil Engineering
Associate Director of NEXTOR
Virginia Tech
Blacksburg, VAApril 21, 2003
Virginia Tech
2 of 31
Outline of this Presentation
•
A human factors problem
•
How important are markings
•
Why standardized markings
•
Various marking schemes
•
Lights
•
Approach light types
•
Signage
Virginia Tech
3 of 31
A Human Factors Problem
•
Cockpit visibility is an issue during approach and landing operations
•
Aircraft usually fly a 3 degree approach slope but the actual fuselage deck angle might be 7-10 degrees with the horizontal
Visibility Cone
Runway
Aircraft
Flight Path
Virginia Tech
4 of 31
Aircraft Approach Attitude
Consider the aircraft attitude during the landing roll on why markings are important
B727-200Flare
TouchdownMarkings
Virginia Tech
5 of 31
Runway Markings
•
For detailed information refer to FAA Advisory Circular 150/5340-1H
•
There are six basic runway markings:
• Runway designation
• Centerline
• Threshold markers
• Touchdown zone
• Side stripes
•
Two runway ends can have different runway markings
•
When runways intersect use runway marking precedence rules (see page 3 in AC 150/5340-1H)
Virginia Tech
6 of 31
Runway Markings (FAA)
There are three basic runway marking arrangements
Virginia Tech
7 of 31
Runway Markings
Touchdown Marks (1000 ft.)
Threshold Marks
Runway Identification Number
Runway Edge Marks
Runway Centerline Marks
Runway Turnoff
Runway Shoulder
Virginia Tech
8 of 31
Table for Runway Markings
Source: FAA AC 150/5340-1H
Virginia Tech
9 of 31
Runway Designation Markings
•
Designates the runway magnetic azimuth (remember to divide by 10)
•
White color
Virginia Tech
10 of 31
Runway Designation Markings
Runway Number
Threshold Markers
150 ft
Runway CL Marks
20-30 ft
Virginia Tech
11 of 31
Runway Threshold Markings
•
Two configurations:
•
Configuration A - Fixed number of threshold stripes (8)
•
Configuration B - Variable number of threshold stripes
Virginia Tech
12 of 31
Runway Aiming Point Markings
•
Provide guidance on where to land on the runway
•
Typically start 1,020 ft. from the runway threshold (an allowance of +/- 200 ft. is possible if runway intersections are to be avoided)
•
Two large rectangular markings (150 x 30 ft.)
•
White color
•
For narrow runways reduce the width proportionately. No reduction in length is needed.
Virginia Tech
13 of 31
Runway Aiming Point Markings
Threshold Markers
Aiming Point Markers
1,020 ft.
Virginia Tech
14 of 31
Runway Touchdown Zone Markings
•
Identify touchdown zone areas
•
Groups of one, two and three rectangular bars
Runway Number
150 ft
Runway TD Markers
Virginia Tech
15 of 31
Runway Side Stripes Markings
•
Delineate the runway from surrounding terrain
•
Part of the usable runway
•
36 inches in width for runways 100 ft. or wider
•
18 inches if runway width is less than 100 ft.
• Extend to the displaced threshold (if available)
Virginia Tech16 of 31
Runway Side Stripe Markings
Runway CL Marks
CL Taxiway
Runway Side Stripe Markings
Virginia Tech17 of 31
High-Speed Exit Markings
Runway CL Marks
CL Taxiway
Virginia Tech18 of 31
HS Exit Markings
HS exits deserve special attention because they are seldom used at the design speed by pilots
REDIM 3520 Geometry35 m/s Design Exit Speed20 Degree Exit Angle
Virginia Tech19 of 31
Holding Line Markers
• Delineate positions on taxiways where pilots are expected to hold short of the runway
• Also used in Landing and Hold Short Operations (LAHSO) - operations in intersecting runways
Source: Table 4 in FAA AC 150/5340-1H
Virginia Tech20 of 31
Taxiway Markings
Taxiway markings provide guidance during good and bad weather conditions (note the yellow markings)
Cessna 650
Taxiway Centerline
Holding LineMarks
Markings
Virginia Tech21 of 31
Approach Lights
• Provide navigation guidance to the runway
• Vertical and lateral guidance
• Several types of approach lighting systems have been developed
• Check technical specifications at Honeywell web site at http://airportsystems.honeywell.com/airfieldlighting/productfamilies/approachlights
Virginia Tech22 of 31
Approach Lights Categories
• ALSF I and II - single and three intensity lighting system (typically 2,400 ft. or longer)
• MALSF - medium intensity lighting system (1,400 ft.)
• ODALS - Omnidirectional approach lighting systems
• SSALR - high-intensity lighting system (2,400 ft.)
• MALSR - medium intensity system (2,400 ft.)
• MALS - medium intensity system (1,400 ft.)
Virginia Tech23 of 31
Typical Approach Lights
The approach lights provide roll guidance during landing (very important during low visibility operations)
2000 ft3000 ft
Virginia Tech24 of 31
Sample View from the Cockpit
Another sample of precision approach lights as viewed from 1000 ft (note the color of these lights)
HS Exits
Touchdown Lights
Runway EndIdentififierLights (REIL)
Virginia Tech25 of 31
Detail of High Speed Exit Lights
HS exit lights are shown in more detail in this figure
REIL
HS Exit Lights
Touchdown Lights
Virginia Tech26 of 31
Placement of Runway Touchdown Lights
Runway lights are flushed on runways to avoid damage to the aircraft landing gear
26 inches
MountingSupport
17” inchPCCRunway
Virginia Tech27 of 31
Runway Light Fixtures (RLF)
RLF are frangible structures located near the runway or taxiway shoulders
Shoulder
Light Fixture
Virginia Tech28 of 31
Apron Lights
Apron areas need to be properly lighted to help pilots guide aircraft under adverse weather conditions
UPS Boeing 747
PW JT9D-7REngine
Virginia Tech29 of 31
Apron Lights (Deicing Crane)
Deicing sections near runways or aprons have to be properly lighted to avoid ground collisions
245 ft
Adjustable DeicingCrane at UPS
Facility
Virginia Tech30 of 31
Airport Signs
Airport signs are very important to provide guidance on runways, taxiways and apron areas
36 inches
Virginia Tech31 of 31
Runway Length Markers
Remaining runway markers are very critical to pilots during takeoff roll manuevers
In this case theremaining runwayis 6,000 ft long