„INO DECK“ Mounting recommendations€¦ · Beam 25x50x3000/4000 TS Rear profile LR1...
Transcript of „INO DECK“ Mounting recommendations€¦ · Beam 25x50x3000/4000 TS Rear profile LR1...
Beam 25x50x3000/4000
TS Rear profile LR1 20x125x3000
T
„INO DECK“ Mounting recommendations
ELEMENTS
Corner profile K55x55x3000
TTerrace decking boards:138x26 - Classic; 140x26 - Solid26; 136x20 - Solid20
Adj. supportsh 20 - 1020 mm
ClipTTE-N
Mounting principles Recommended d It is necessary to leave min 10 mm gap between boards and end profiles or walls (A,B,C). It is unacceptable exceeding the edge of the lag by the board more than 30 mm or fixing of boards less than in three places. WPC beams TS is used only on smooth hard surface (eg. concrete), otherwise please use galv. metal or Alu underconstruktion.
istance between beams centers (not more): for , for and for . DBC Solid20 - 400 mm hollow boards - 500 mm Solid26 - 600 mm
In order to ensure free water flow when mounting a plinth plank, the plank cannot exceed the limits of the board to the height.
* The WPC raw material has natural wood fiber inside, that's why color saturation may change from sunlight and moisture (usually stabilizes in 6-8 weeks). In addition each batch ( sometimes even inside) may have a slight mismatch of color saturation.
The customer is familiar to the information provided above.*Any claims must be brought before mounting.
Start clipTET-03
DB
C
400 - 6
00
300
< 1000
min 10 mm
Terrace beam
The rear planks must be fastened with prel. boring
The beams must be fastened to the base. Two beams are used for boards connection (10 mm gap)
Clip
Rear/ Corner profile
Terrace board
Terrace Beam
o2-3
Clip
Terrace board
Terrace Beams
Clip
Terrace board
min 10 mm
AA CB
1 2 3 4 5
6
5 6
1
2 3
4
B C
DBC