AGS-1800 AUTO STACKER - Square 1 Design
Transcript of AGS-1800 AUTO STACKER - Square 1 Design
AGS-1800 AUTO STACKER
®
BR-SQ-AGS-0313
SPECIFICATIONS
Sean Hubbard
Phone: 317-440-2804
Fax: 320-210-4237
®
The AGS-1800 Automated Truss Stacking System was designed with
VERSATILITY in mind. It can handle 120’ agricultural trusses with
ease. Even 120’ heavy gable ends weighing 2000# are no match for this
stacker. Its A-frame design makes a superior base to support the largest
trusses. Each pedestal will hold from 10 to 25 trusses depending on size
and weight. The individual drive system, allows any combination of
stacking options; any combination of 9 pedestal can be stack up to 3 zones
in 120’.
The Available Options Are Unparalleled
*Touch Screen Controls *Remote Control Mode
*Automatic Mode *Manual Mode
*On screen Diagnostics *3 Target Zones
*Individual Pedestal Selection *Truss Counting
*Auto Vertical Slide Arm Retract *Auto Vertical Slide Arm Return
*Heated for Winter Applications *Weather Resistant
*Replaceable Lift Arms *Guarded
*Single Frame Design *Rapid Install Time
*Individual Motor Diagnostics *Define Independent Truss Stacks
*Superior Lifting Capabilities *Frame Mounted Motors
High torque braking gear motors use a unique cam arm design to lift the
arms and return them to the home position smoothly in approximately 35
seconds. Cam follower equipped carriers mounted on each pedestal are
mechanically driven to position. A wide variety of AGRI-STACK units
are available. We manufacture systems for Floor Trusses and Roof
Trusses. Combine any of these systems with the Square 1 Outside
Conveyors, and the AGRI-STACK truss stacking system will meet all
your requirements.
AGS-1800-04-0513 AUTOMATED ROOF TRUSS STACKER
Four Pedestal dual or quad motor design
Used to stack roof trusses from 14’ to 70’
AGS-1800-05-0513 AUTOMATED ROOF TRUSS STACKER
Five Pedestal dual or quad motor design
Used to stack roof trusses from 8’ to 70’
AGS-1800-09-0513 AUTOMATED ROOF TRUSS STACKER
Nine Pedestal, individual pedestal motor design
Used to stack HEAVY Agricultural and
Large Residential roof trusses up to 120’
Specification subject to change without notice!
Guarded motor and pedestal design Lift Arm and
Alternating Conveyor Roller Design
High Torque Replaceable Lift arm
With Integrated Cam
Multi-Pedestal, Single Frame Design
Jay Bunyard
Phone: 317-354-5438
Fax: 320-210-4237
Email: [email protected]
Select Mode Select Target Zones Assign Pedestals to Target