AE 221 project The Ismail residence By Mosope Ismail Location: No 4 sharafadeen shoyege Magodo...
-
Upload
javion-letson -
Category
Documents
-
view
218 -
download
2
Transcript of AE 221 project The Ismail residence By Mosope Ismail Location: No 4 sharafadeen shoyege Magodo...
AE 221 project
The Ismail residence By Mosope Ismail
Location: No 4 sharafadeen shoyege Magodo Estate Lagos Nigeria
Professor: Paul Bowers
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections
⋆ Perspectives and renderings
Outlines: EAGLE EYE OF HOME SITE PLAN
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections
⋆ Perspectives and renderings
Category : Residential (R1) Size: living area = 4,300 sq.ft each floor : Property size = 9,534 sq ft Features : side patio on property space
3D VIEW PROPERTY INFORMATION OUTLINES:
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections
⋆ Perspectives
⋆ Renderings
FLOOR PLANS
Wall paper
Wood panel finishing
RENDERED VIEWS
Ceiling tray frames
First floor
Second Floor Plan
OUTLINES:
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections
⋆ Perspectives
⋆ Renderings
acoustic ceiling finishing tile
Red and white carpet
Laminate particle board
ELEVATIONS RENDERED ELEVATIONS
South face
North face East Face
OUTLINES:
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections and Details
⋆ Perspectives and Renderings
DETAILS SECTIONS
Wall detail
Foundation Detail
East Side section
West side section
OUTLINES:
⋆ Overview
⋆ Zoning
⋆ Plans
⋆ Elevations
⋆ Sections
⋆ Perspectives and renderings
RENDERINGS PERSPECTIVES
Gym
Dining
Rendered Gym
Rendered Dining
Office Area Rendered Office Area
OUTLINES:
CEILING TRAY FRAMING
Material specialization • Location• Color and size • Quantity • Warranty and manufactures • Material cost and Availability • Installation and materials needed Animation (movie)
What are wall tray ceiling ? :A tray ceiling is a rectangular architectural feature that is either inverted or recessed. Tray ceilings can be plain, ornate, subtle or dramatic. Lighting is commonly featured in this design, and these ceilings are often found in dining rooms, hallways and living rooms.
Why do we use them?: The basic purpose of a tray ceiling is to break up an ordinary flat ceiling line and add a variation in height to create architectural interest
Location: Located on the finished façade of the ceiling
Color : After the white cast has been placed it can be painted any color
Size is based on requirements with CaS04.2H2O, but with plastic they of standard
Quantities : are based on surface area
Size 14-1/8" x 7-5/8" x 1-3/8" H
Section 2 x 6
Thickness 1.5mm
INFORMATIONOUTLINES:
Material specialization • Location• Color and size • Quantity • Warranty and manufactures • Material cost and Availability • Installation and materials needed Animation (movie)
TRAY CEILING FRAMING
Manufactures:
Warranty: lifetime upon installation
COST!!!!!
This work can be completed in 1 to 2 days. Depending on the number of labor available
The typical Tray Ceiling Framing project involves tasks that are best performed by experienced professionals. Good quality Tray Ceiling Framing requires considerable experience, skill and attention to detail. Do it yourself mistakes are noticeable, may be difficulty to remedy and may actually reduce the market value of the project and your home.
INSTALLATION TRAY CEILING FRAMING
Snap a chalk line down the ceiling and wall the width and height of the tray, then nail in a 2x4 to the chalk line. Cut 1/2" OSB to the height measurement of the tray and nail a 2x4 on the flat side flush to the factory cut edge on the OSB.
Install the first run to the 2x4 on the ceiling. Take the total width measurement and subtract 3-1/2" to cut two 2x4 blocks. Put one block in each corner and then string a line from one corner to the other.
Run a quick layout at 16" on center on the 2x4 on the wall and the 2x4 on the OSB. Next go to the center layout mark of the tray and adjust it to the string line, then measure the 2x4 block that is needed. Repeat this until all the blocks are in. That now completes one run of the tray ceiling. Repeat these steps to finish up.
#Tape Measure # Saw
# Hammer #Chalk Line
# 2x4s #1/2 “ OSB
MATERIALS OUTLINES:
Material specialization • Location• Color and size • Quantity • Warranty an manufactures • Material cost and Availability • Installation and materials needed• Materials Animation (movie)
Material specialization
• Location• Specifications • Material cost and Availability • Installation • Approvals , Inspections Animation (movie)
Design approval and permits from your local building authority are usually not required for Tray Ceiling Framing. If your home is subject to homeowner association covenants, you should verify that the Tray Ceiling Framing complies with association guidelines
The operation and performance of the Tray ceiling framing may be adversely affected by inexperience or poor installation techniques. Hire service providers for Tray Ceiling Framing carefully and be sure to tie payment milestones to appropriate quality checks .
If you are not familiar with the materials don’t try to install this yourself
CONCLUSION OUTLINES:
•