Advanced Engineering Design and Presentation Copyright © Texas Education Agency, 2014. All rights...

1

Advanced Engineering Design and Presentation

Copyright © Texas Education Agency, 2014. All rights reserved.

Pipe Parametric Modeling

Skill Builder and

Crazy Straw Prototype

2

The Pipe Objective


The pipe objective is to teach you how to use the sweep path tool. You will then use this knowledge to create your own unique “Crazy Straw” prototype.

6

Finish the sketch and a work plane to match this.


7

Create a new sketch on the work plane.


8

Draw these lines to match. (60 – 40 – 40)


9

Exit sketch mode and drawing should look like this.


10

Add another work plane.


11

Rotate it, select the work plane, and create a 3D sketch. Select the Include Geometry button, and then select the six lines drawn.


12

Drawing looks like this before the lines are selected.


13

After you have selected all of the lines and created 15mm Bends, the color changes to yellow.


14

Drawing should look like this.


15

On the 2nd work plane, draw two circles (DIA = 4 and 6).


16

Drawing should look something like this.


17

Create a Model - Sweep Profile - this part of the two circles.


18

Path = what you drew (red line)


19

The Pipe should look like this.


20

Change the material to galvanized.


Advanced Engineering Design and Presentation Copyright © Texas Education Agency, 2014. All rights...

Documents

Transcript of Advanced Engineering Design and Presentation Copyright © Texas Education Agency, 2014. All rights...