About Connection Types
-
Upload
tmavroidis -
Category
Technology
-
view
436 -
download
2
description
Transcript of About Connection Types
![Page 1: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/1.jpg)
About connection typesAbout connection types
Things to think aboutThings to think about
![Page 2: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/2.jpg)
BandwidthBandwidth
In digital systems, bandwidth is the data speed in bits per second (bps). As a relative example, an analog television signal has a bandwidth some 2,000 times as “wide” as an analog telephone voice signal.
![Page 3: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/3.jpg)
Why is bandwidth Why is bandwidth important?important?
The greater your bandwidth the faster The greater your bandwidth the faster you can transfer data.you can transfer data.
For internet servers your uplink For internet servers your uplink bandwidth should be equally as fast as bandwidth should be equally as fast as your downlink.your downlink.
Uplink is the speed you feed Uplink is the speed you feed information to the internetinformation to the internet
Downlink is the speed you can get Downlink is the speed you can get information from the internetinformation from the internet
![Page 4: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/4.jpg)
Baud & kbpsBaud & kbps
Baud was the prevalent measure for data transmission speed until replaced by a more accurate term, bps (bits per second). One baud is one electronic state change per second, which change can involve more than a single bit of data.
Kilo-Bits Per Second. One Kbps is equal to 1,000 bits transmitted in one second, and is a measure of bandwidth. Higher bandwidths are expressed in megabits (Mbps), millions of bits per second, and in gigabits (Gbps), billions of bits per second.
![Page 5: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/5.jpg)
Cable ModemCable Modem
Using a cable modem you can achieve a high speed connection to the Internet. But, a cable modem is not a modem at all. It is a broadband network bridge. A device that "bridges" the radio-wave-like signals carried by cable TV into a signal that is used by a standard Ethernet LAN connection. You plug the output of the cable modem into an Ethernet network card attached to your computer system.
![Page 6: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/6.jpg)
DSLDSL
Digital Subscriber Line. Also known as xDSL, it is the general term applied to a whole family of high-speed digital data products. A for Asymmetric, H for High speed, and S for Symmetric. These technologies are expected to be the high-speed data products that will someday replace existing technologies like ISDN and Fractional T-1 lines. With DSL service, you can receive data at rates up to 6.1 Mbps, out of a theoretical 8.448 Mbps. More typically, individual connections will provide from 1.544 Mbps to 512 Kbps downstream and about 128 Kbps upstream. A DSL line can carry both data and voice signals at the same time, and, the data part of the line is continuously connected.
![Page 7: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/7.jpg)
ADSLADSL
Asymmetric Digital Subscriber Line. ADSL is an asymmetric technology, where the speed of the link to you is higher than the speed of the connection sent by you. You may have only 128 Kbps of outbound bandwidth, but may be able to receive data at speeds of 8 Mbps.
![Page 8: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/8.jpg)
HDSL & SDSLHDSL & SDSL
High bit-rate DSL. HDSL is symmetrical. For this reason, the maximum data rate is lower than for ADSL.
Symmetric DSL. SDSL is similar to HDSL.
![Page 9: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/9.jpg)
Fractional T-1Fractional T-1
• A full-blown T-1 data connection that has been Fractionalized, or set up so that it offers data throughput only a fraction of standard 1.54 Mbps T-1 speed. Offered in a range of speeds (128, 254, 382, 512, and 764 Kbps), they costing less than the full T-1.
![Page 10: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/10.jpg)
ISDNISDN
• Integrated Services Digital Network. A digital telephone line that can be used for voice, fax, and data communications like a regular analog telephone line, but can transport data about two and one-half times faster than a 56 Kbps modem and allows you talk on the phone with one person while sending data to another.
![Page 11: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/11.jpg)
POTSPOTS
Plain Old Telephone Service. A term that refers to a standard analog telephone line using the standard that hasn't changed since the 1930s, when rotary-dial telephones became available.
![Page 12: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/12.jpg)
T1T1
A digital data connection that operates at 1.54 Mbps and requires a two-pair, four wire, connection between the telephone company Central Office and your home or business. It was introduced in the U.S. in the 1960s – yes, the 1960s. At a higher level, the T-3 line provides 44.736 Mbps.
![Page 13: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/13.jpg)
Comparison of relative Comparison of relative speedsspeeds
Regular telephone service or POTS: up to 56 Kbps
ISDN: 64 Kbps to 128 Kbps Cable modem: 128 Kbps to 1+ Mbps xDSL: 512 Kbps to 8 Mbps T-1: 1.544 Mbps T-2: 6.312 Mbps
T-3: 44.736 Mbps
![Page 14: About Connection Types](https://reader036.fdocuments.us/reader036/viewer/2022082920/5554c806b4c90559398b5393/html5/thumbnails/14.jpg)
ConslusionConslusion
Before selecting a connection you Before selecting a connection you must determine what traffic you must determine what traffic you expect. The higher the demand, expect. The higher the demand, the greater your bandwidth should the greater your bandwidth should be. While Cable and ADSL is fine be. While Cable and ADSL is fine to use for internal web surfing you to use for internal web surfing you wouldn’t want to host a site wouldn’t want to host a site because of the poor uplink speeds.because of the poor uplink speeds.