Aaron Thomas Jacob Wefel Tyler Sneen. By the end of this lesson we will introduce the terminology...

13
Section 1.2 Functions and their Properties Aaron Thomas Jacob Wefel Tyler Sneen

Transcript of Aaron Thomas Jacob Wefel Tyler Sneen. By the end of this lesson we will introduce the terminology...

Page 1: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Section 1.2 Functions and their Properties

Aaron ThomasJacob WefelTyler Sneen

Page 2: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Funny Introduction

Page 3: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Introduction

By the end of this lesson we will introduce the terminology that is used to describe functions

These include: Domain, Range, Continuity, Discontinuity, upper and lower bound, Local and absolute maximums and minimums, and asymptotes

Page 4: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Domain and Range

The domain of a function is all of the possible x-values the function can have. It can be expressed as an inequality

The Range of a function is all of the possible y-values the function can have. It is also expressed as an inequality

Page 5: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Domain and Range Example

Domain: All Real Numbers Range: All Real Numbers

Domain: x> -1 Range: x>-5

Page 6: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Discontinuity

A graph has continuity if its graph is connected to itself throughout infinity. There are no asymptotes or holes in the graph

A Graph has removable discontinuity if its graph has a hole where one x value was removed from the domain

A graph has infinite discontinuity if its graph has an asymptote that can not be replaced with only one value

Page 7: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Discontinuity Example

Jump Discontinuity Removable Discontinuity

Page 8: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Bindings

A function is bounded above or below if the graph’s range doesn’t extend past a certain point above or below.

A function is “Bounded” if the function’s range doesn’t extend below or above certain points

If the function has no restrictions on its range’s extent the function is considered “unbounded”

Page 9: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Bindings Example

This sine function is bounded above and below at 1 and -1

Page 10: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Max and Mins

A Local Maximum/Minimum of a function is the highest/lowest point of the range in the surrounding window of the graph

The absolute maximum/minimum of a function is the highest/lowest point of the entire range of the graph

Page 11: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Max and Min Example

Local Min: 3, -4, 4 Local Max: 5 Absolute Max: None (Graph goes

infinitely upward) Absolute Min: -4

Page 12: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Asymptotes

A horizontal asymptote is a part of the function which gets infinitely close to a Y-value but never touches it

A Vertical asymptote is a part of the function which gets infinitely close to a x- value but never touches it

Page 13: Aaron Thomas Jacob Wefel Tyler Sneen.  By the end of this lesson we will introduce the terminology that is used to describe functions  These include:

Asymptotes Example

Identify any horizontal or vertical asymptotes of the graph of

You would first start by foiling the denominator… = (x+1)(x-2)

This means that the graph has vertical asymptotes of x=-1 and x=2

Because the denominator’s power is bigger than the numerator’s, y = 0 no matter what the value of x is

Now you have x/((x+1)(x-2)) = 0 This means that the horizontal asymptote is

zero