CONTENT

INTRODUCTION

OBJECTIVE OF THE STUDY

SCOPE OF STUDY

WORK DONE

LITERATURE REVIEW

FUTURISTIC USE OF STUDY

PROPOSED METHODOLOGY

REFERENCES

What is Green Building?

Green building is the practice of increasing the efficiency of buildings and their use of energy, water, and materials, and reducing building impacts on human health and the environment, through better siting, design, construction, operation, maintenance, and removal taking into account every aspect of the complete building life cycle.

Most characteristics of the composite zone

are similar to that of the hot and dry climate

zone, except that composite regions

experience higher humidity levels during

monsoons. In this type of climate two seasons

occur normally. Approximately two-thirds of

the year is hot-dry and the other third is warm-

humid. Localities further north and south often

have a third season,best described as cool-

dry.

In India most of the region comes

under two types of climate that is

composite and hot and dry

HIGH PERFORMANCE BUILDINGS

HIGH PERFORMANCE BUILDINGS

DEFINITION OF HIGH PERFORMANCE

BUILDINGS. In this section, the term high performance building means a building that

integrates and optimizes all major high-

performance building attributes, including

energy efficiency, durability, life-cycle

performance, and occupant productivity.

Orientation

Orientation: NE, SW This helps in receiving less radiation which results in lesser heat gains and reduced the overall air-conditioning requirement and hence saves energy. Proper orientation also helps in receiving natural light and ventilation

APPROPRIATE HEIGHT AND RECESSED WINDOWS Minimum height above the ground level to limit exposure to external conditions. Recessed windows to reduce external solar heat gains.

Water Body

USE OF WATERBODIES FOR EVAPORATIVE COOLING

Fountain to flow over extensive surfaces to maximize evaporation. Water evaporation has a cooling effect in the surroundings.

POSITION OF OPENINGS In buildings air movements must be ensured through the space mostly used by occupants: through the living zone(up to 2m high).

SIZE OF OPENINGS The largest air velocity will be obtained through a small inlet opening with a large outlet. The best arrangement is full wall openings on both the sides , with adjustable sashes or closing devices which can assist in channelling the air flow in the required direction , following the change of wind. CONTROLS OF OPENINGS A gap left between the building face and canopy would ensure a downward pressure ,thus a flow is directed into the living zone.

Deciduous plants can serve a useful purpose.

TREATMENT TO THE EXTERNAL SPACES

Large projecting eaves and wide verandahs are needed in composite climate as out-door living areas, to reduce sky glare, keep out the rain and provide shade.

Brise-soleils, louvers and other sun breaks used to protect openings during the hot-dry periods ,are also advantageous in the rainy season, serving as protection against dust and thermal winds.

A courtyard is the most pleasant out-door spaces for most of the year, because it excludes the winds and traps the sun. It should be designed in such a way so as to allow sun penetration during the winter months, but provides shading in the hot season.

The U-value which is much higher incase of normal glass increases the solar heat gain and the energy consumption

WALL WITHOUT INSULATION

WALL WITH INSULATION

Insulation helps retain cool in summer and heat in winter, and acts as sound proof. This can create a major impact on indoor thermal comfort of the building.

Insulation Insulation is very important in green construction because it helps conserve energy.

In the past, ASBESTOS was used for insulation, but it has since been banned or restricted in many countries because of health hazards.

Good sustainable choices for insulation are those made from recycled newspaper and wood

pulp, soy, cotton, recycled plastic or cork.

Roofing An important feature of green roofing

is its durability; sustainability can often

be as simple as avoiding or limiting

waste. Composite cedar shingles

resist moisture, mildew and insects,

which extends their life.

Metal roofing materials that have solar

reflective qualities also have

advantages, especially in hot

climates.

Glass Windows constructed of layered panes separated by sealed, gas-filled compartments

provide insulation that conserves energy. windows and doors can also be covered in

special low-emissivity coatings that use or block natural solar rays to help regulate

indoor temperatures.

Properly designed roof gardens help to

reduce heat

loads in a building

Landscaping

Landscaping is an important element in altering the microclimate of a place.

Proper landscaping reduces direct sun from striking and heating up of building

surfaces. It prevents reflected light carrying heat into a building from the

ground or other surfaces.

USE OF ECO-FRIENDLY MATERIALS Eco friendly materials are describe as :a product that has been designed to the least possible damage to the environment.

Why eco friendly materials? Phenomenal growth in the construction industry that depends upon depletable resources. Production of building materials lead to irreversible environmental impact.

ENERGY CONSERVATION

USE OF

RENEWABLE

SOURCE OF

ENERGY

Use of

appliances

that consume

less energy

Planting trees helps in

maintaining ecological

balance thus reducing

energy consumption

Use of

water

bodies for

evaporative

cooling

Use of

reflective

surfaces

for

minimum

heat gain

Use of Passive means rather than active means

Traditional Jharokha in Jaipur, Rajasthan

provides light, & ventilation while avoiding

dust and glare

Passive design strategies Indirect cooling includes ventilation and stack effect and

venture effect, belvedere, roof pond, earth air tunnel, courtyards and Malkaafs, wind

scoops and wind towers.

ROOF POND

Evaporative cooling systems uses evaporation as a cooling method in cooling the

surrounding air by adding moisture in the air hence increasing humidity. It is a low energy

passive system. The following sections are categorized into sections stating the required

conditions, implementation considerations and other issues. Case studies are listed as

reference to discuss on how these systems are implemented and the implication they

have on architecture design.

PASSIVE DOWNDRAFT EVAPORATIVE COOLING

WATER RESOURCE MANAGEMENT Reducing water consumption and protecting water quality are key objectives in sustainable building.

One critical issue of water consumption is that in many areas, the demands on the supplying aquifer exceed its ability to replenish itself.

To the maximum extent feasible, facilities should increase their dependence on water that is collected, used, purified, and reused on-

site.

The protection and conservation of water throughout the life of a building may be accomplished by designing for dual plumbing that

recycles water in toilet flushing

WASTE REDUCTION

Green architecture also seeks to reduce waste of energy, water and materials used during construction.

During the construction phase, one goal should be to reduce the amount of material going to landfills.

Well-designed buildings also help reduce the amount of waste generated by the occupants as well, by providing on-site solutions

such as compost bins to reduce matter going to landfills.

Use of locally available materials and sustainable energy sources have been used extensively in the building. Natural lighting and ventilation enhance the energy-efficiency of the building. Adequate green spaces help in controlling the micro-climate providing visual delight at the same time.

Aerial view of CII-Godrej GBC, Hyderabad showing wind towers, solar photovoltaic panels and

green roofs.

CII-Godrej GBC, Hyderabad

Architectural Design The building is designed to maximize usage of natural light for day-lighting without getting unwanted heat inside. The ground surface covered by the building is replaced through roof gardens which play a major role in insulating the building.

Unwanted gain of heat is reduced through simple design principles like earth berming. Heat gain through openings is also reduced through intelligent design of windows.

Roof gardens insulate the building from solar heat

An effective combination of closed and open spaces help in modulating the micro-climate so that it keeps the building cool and well-ventilated. There is ease of access throughout the site.

PHOTOVOLTAIC PANELS

Solar energy is used to generate electricity that is used in the building.

Solar photovoltaic panels on the roof generate electricity for the building

Wind towers Wind towers carry air through an earth air tunnel to cool it before being supplied to the AHUs.

Jaalis on the outer faade of the building also help in cooling, shading and ventilation of the building.

Use of Renewable source of Energy

Effective measures are taken to properly ventilate the building while saving energy at the same time. Air caught by the wind towers is carried through an earth-air tunnel which pre- cools the air entering into the AHUs. This saves energy required in the cooling process.

Day lighting

Emphasis is laid on providing adequate day-lighting.

Intelligent design of windows such as different windows for views and for light reduce the heat gain.

Materials & Appliances Use of local materials and materials with is visible at various places. For instance, local stone and waste construction materials are used for external cladding. low-embodied energy

There is a vast difference in the amount of glazed areas on the northern and western sides of the building. Such features

prevent unwanted heat gain.

Futuristic use of study

With increasing population human needs are also increasing day

by day which has resulted in various ecological problems. Now a

days with advancement in technology there is increase in basic

needs of people and there is no more the time when people

required only three things for living that is roti, kapda or makan they dont want normal roti nor normal kapda and neither makan. People now a days are more addicted to active means which has

resulted in more and more consumption and thus disturbing

ecological balance. An ideal citizens duty is to not only think about his generation but also for future and thus there isv a great need

of buildings which are dependent mostly on passive means and

studying this topic makes us aware of the methods by which we

can create an environment which is eco-friendly.

Two types of windows designed: peep windows for possible cross ventilation

and view, the other being for day lighting

Shading by vegetation (trees and creepers)

cooling through evaporation by water surfaces and plants (except

during monsoon)

cooling through earth tunnel system

EARTH TUNNEL SYSTEM

COURTYARD

IMPLIMENTATION IN DESIGN

Literature survey about composite climate and scope of this topic in India

Literature survey on high performance buildings in composite climate

Compared those elements with live examples like retreat

Implemented those ideas in design project done in previous semester