920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update...
-
Upload
truongtuyen -
Category
Documents
-
view
233 -
download
1
Transcript of 920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update...
![Page 1: 920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update Procedure ** You must use a USB Flash Drive 2.0. A 3.0 will not work. USB 2.0 is](https://reader036.fdocuments.us/reader036/viewer/2022062401/5a754d4e7f8b9a1b688c4a07/html5/thumbnails/1.jpg)
920 Firmware Update Procedure
** You must use a USB Flash Drive 2.0. A 3.0 will not work. USB 2.0 is white, and USB 3.0 is blue as
indicated in the picture below.
1. Contact Lite-Check, LLC or download the firmware from the link on the website www.lite-
check.com to obtain the Firmware.
2. Ensure the software “image.hex” is UNZIPPED! You can do this by right clicking on the folder
and selecting EXTRACT ALL. Make sure you DO NOT CHANGE THE NAME OF THE FILE
“image.hex”. Copy and paste the software onto a USB 2.0 Flash Drive device, it must be named
“image.hex”
3. After removing power from the 920, remove the screws securing the rear panel
4. Carefully open the back of the 920 to avoid damaging the ribbon cables and connectors
![Page 2: 920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update Procedure ** You must use a USB Flash Drive 2.0. A 3.0 will not work. USB 2.0 is](https://reader036.fdocuments.us/reader036/viewer/2022062401/5a754d4e7f8b9a1b688c4a07/html5/thumbnails/2.jpg)
5. Insert the USB Flash Drive in the USB socket
6. Reconnect the 920 to its 12 volt power source
7. Press SW2 (PGM_N) while turning on the 920 with the power switch
![Page 3: 920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update Procedure ** You must use a USB Flash Drive 2.0. A 3.0 will not work. USB 2.0 is](https://reader036.fdocuments.us/reader036/viewer/2022062401/5a754d4e7f8b9a1b688c4a07/html5/thumbnails/3.jpg)
8. Release SW2
9. When the display comes on with the banner message and then the normal display, turn the 920
off
10. Remove power from the 920
![Page 4: 920 Firmware Update Procedure - Lite-Check.com Firmware Update Procedure.pdf · 920 Firmware Update Procedure ** You must use a USB Flash Drive 2.0. A 3.0 will not work. USB 2.0 is](https://reader036.fdocuments.us/reader036/viewer/2022062401/5a754d4e7f8b9a1b688c4a07/html5/thumbnails/4.jpg)
11. Remove the USB Flash Drive
12. Reattach the rear panel using the screws removed in step 3
13. Reconnect the 920 to its 12 volt power source
14. Turn on the 920 and verify correct operation