page 1/2

February 20102 pages Revision of September 2005

SIGMATEX

water borne thixotropic decorative wall paint based on latex emulsion

– is unsaponifi able and therefore suitable for painting alkaline surfaces to be used as decorative quick drying fi nish on walls and ceilings in –accommodation, cabins, passage ways etc. and for plastered pipelines resistant to wet scrubbing, easy to clean – eliminates porosity of substrates and is water vapour permeable – no bleeding when applied over bituminous surfaces – low odour during application – very good hiding power – must not be used at air/substrate temperature below 5°C –

white (can be tinted) - fl at

(1 g/cm³ = 8.25 lb/US gal; 1 m²/l = 40.7 ft²/US gal) 1.5 g/cm³ 42 ± 2% max. 0 g/kg (Directive 1999/13/EC, SED) max. 0 g/l (0 lb/gal) 7 - 10 m²/l, depending on type and structure of substrate 30 minutes at a relative humidity of approx. 50% min. 2 hours at a relative humidity of approx. 50% max. no limitations at least 24 months above 65°C

– to be applied in a one or two coat system, gypsum, gypsum board, hardboard, chip board, plastered walls and normal insulation materials the temperature of the substrate must be at least 5°C –

to be applied in two coats

– stir well before use the temperature of the paint should preferably be above 15°C, otherwise –extra thinner may be required to obtain application viscosity too much solvent results in reduced sag resistance –

tap water 0 - 10%, depending on required thickness and application conditions approx. 0.46 - 0.53 mm (= 0.018 - 0.021 in) 16.5 MPa (= approx. 165 bar; 2340 p.s.i.)

tap water 0 - 7%

DESCRIPTION

PRINCIPAL CHARACTERISTICS

COLOURS AND GLOSS

BASIC DATA AT 20°C Mass density Volume solids VOC (supplied) Theoretical spreading rate Touch dry after Overcoating interval

Shelf life (cool and dry place) Flash point

RECOMMENDEDSUBSTRATE CONDITIONSAND TEMPERATURES

SYSTEM SPECIFICATION

INSTRUCTIONS FOR USE

AIRLESS SPRAY Recommended thinner Volume of thinner Nozzle orifi ce Nozzle pressure

BRUSH Recommended thinner Volume of thinner

page 2/2

February 2010

SIGMATEX

tap water

for paint and recommended thinners see safety sheets 1430, 1431 and relevant material safety data sheets

although this is a water borne paint, care should be taken to avoid inhalation of spray mist or vapour as well as contact between the wet paint and exposed skin or eyes

Whilst it is always the aim of PPG Protective & Marine Coatings to supply the same product on a worldwide basis, slight modifi cation of the product is sometimes necessary to comply with local or national rules/circumstances.Under these circumstances an alternative product data sheet is used.

Explanation to product data sheets see information sheet 1411 Safety indications see information sheet 1430 Safety in confi ned spaces and health safetyExplosion hazard - toxic hazard see information sheet 1431

LIMITATION OF LIABILITY

The information in this data sheet is based upon laboratory tests we believe to be accurate and is intended for guidance only. All recommendations or suggestions relating to the use of the Sigma Coatings products made by PPG Protective & Marine Coatings, whether in technical documentation, or in response to a specifi c enquiry, or otherwise, are based on data which to the best of our knowledge are reliable. The products and information are designed for users having the requisite knowledge and industrial skills and it is the end-user's responsibility to determine the suitability of the product for its intended use.

PPG Protective & Marine Coatings has no control over either the quality or condition of the substrate, or the many factors affecting the use and application of the product. PPG Protective & Marine Coatings does therefore not accept any liability arising from loss, injury or damage resulting from such use or the contents of this data sheet (unless there are written agreements stating otherwise).

The data contained herein are liable to modifi cation as a result of practical experience and continuous product development.This data sheet replaces and annuls all previous issues and it is therefore the user's responsibility to ensure that this sheet is current prior to using the product.

The English text of this document shall prevail over any translation thereof.

PDS 8215 107302 white 7000002200

CLEANING SOLVENT

SAFETY PRECAUTIONS

Worldwide availability

REFERENCES