76. Purification and Characterisation of Organic Compound-1 (1)

39
Chemistry

description

organic chemistry notes

Transcript of 76. Purification and Characterisation of Organic Compound-1 (1)

  • Purification And Characterisation of Organic Compounds - 1

  • Introduction necessity of purification.Methods of purification of organic compound.Crystallisation Fractional crystallisation Sublimation Distillation Fractional distillation Steam distillationVacuum distillationDifferential extractionChromatography

  • 3.Detection of elements (Qualitative analysis)

    (a)Detection of carbon(b)Detection of hydrogen(c)Detection of nitrogen(d)Detection of sulphur(e)Detection of halogen(f)Detection of oxygen

  • FiltrationCrystallizationSublimationDistillationDifferential extractionChromatography

  • Only one of the compoundsis soluble in the givensolventeg.Urea and NaphthaleneBenzoic acid and anthracene

  • Most common method for purification of solid organic compounds.Impurities and organic compound have different solubilities in the given solvent.

  • vThe organic compound should be insoluble or sparingly soluble in the solvent at room temperature but readily soluble in hot conditions. vThe impurities should be insoluble in the solvent even in hot conditions.

    vThe organic compound should not react with the solvent.

  • The mixture of benzoic acid (water soluble) and naphthalene (water insoluble) purified by.

  • How will you separate mixture of benzoic acid and napthalene ?benzoic acid (water soluble ) and napthalene (water insoluble)

  • Difference in solubilities of organic compounds and impurities are very less.eg. urea and copper sulphate.

  • Used to separate volatile organic compounds from non volatile impurities e.g. Naphthalene, benzoic acid, anthracene, camphor.

    14.psd

  • A mixture of benzene and anilinecan be separated byalcoholNaOH HClHot water

  • Amines are basic in nature. Therefore, aniline reacts with HCl to form a salt which dissolves in water.Hence, aniline can be separated from benzene by using HCl.Hence, answer is (c).

  • Simple distillation- difference in boiling points of compounds is more than 40C. e.g. chloroform(b. p. 334K) and aniline(b. p. 457K).

  • (ii) Fractional distillation- difference in boiling points of compounds is less than 40C. e.g. acetone (b. p. 329K) and methyl alcohol(b. p. 338K).

  • (iii) Vacuum distillation- used for organic compounds which decompose at or below their boiling points.e.g. Glycerol.

  • (iv) Steam distillation- used for organic compounds which are immiscible with water and are steam volatile. e.g. Aniline.

  • The most suitable method for theseparation of mixture of ortho andpara nitrophenol in the ratio of 1:1isdistillationcrystallisation vapourisationcolour spectrum

  • The boiling point of o-nitrophenol is 210oC and that of p-nitrophenol is 245oC.Therefore, vapours of o-nitrophenol will be formed first (lower boiling point) and collected seperately and vapours of p-nitrophenol will be formed latter.Hence, answer is (a).

  • Used to extract pure organic compounds from their aqueous solution by shaking with organic solvent in which they arehighly soluble.Eg. Benzoic acid from its aqueous solution using benzene.

    15.psd

  • Used to purify small samples. Based on selective adsorption or partition between stationary and mobile phase. Column Chromatography- based on adsorption, used for bulk quantities. Thin layer Chromatography- based on adsorption, used for quantitative analysis.

  • Paper Chromatography- based on partition and used for quantitative and qualitative analysis.

    Gas Chromatography- used to separate and analyse volatile organic liquids.

    High performance liquids Chromatography (HPLC)- used for qualitative and quantitative analysis of organic compounds.

  • Boiling point.

    Melting point.

    Mixed melting point.

  • Detection of C, H, N, halogens P, S, and oxygen.

  • Lassaignes extract is prepared toconvert covalency of organic compound into electrovalency by fusing with Na.

  • When acetic acid and lead acetatesolutions are added to sodiumextract, black percipitate is formed.It shows that organic compound has_____ element.chlorineoxygenphosphorussulphur

  • Hence, answer is (d).It shows the presence of sulphur in organic compound.

  • Presence of oxygen in organic compound is detected by testing for functional group containing oxygen eg- alcohol (OH), aldehyde (CHO), ketone (RCOR), carboxylic acid (COOH), ester (COOR) and nitro (NO2).