6X6 hunting blind - hw.menardc.com · 6x6 ELEVATED BLIND INSTRUCTIONS VERTICAL FRAME ×2 FLOOR...
Transcript of 6X6 hunting blind - hw.menardc.com · 6x6 ELEVATED BLIND INSTRUCTIONS VERTICAL FRAME ×2 FLOOR...
1) Cut 8 - 2×4s and 2 - 2×6s @ 72'' in preparation for building the frames.2) Build the two frames as pictured to the right. Be sure to extend the boards1½'' past the 12' frame uprights.3) Cut 8 - 2×4s and 2 - 2×6s @ 69''.4) Stand upright frames and attach theframes with the 69'' boards by lining up the boards with the end 1½'' overhangs.5) Once the structure is standing, framethe floor as shown with 2×6s.6) To frame the roof, cut the top of the rafter to a 4/12 pitch and cut the bottom to match the laterals. Connect the rafters with a 2×4 on each side flush with the peak of the rafters to make the ridge.NOTE: Exceeding the 70'' rise will require longer material for the uprights. Diagonal bracing may be added depending on height.
6x6 ELEVATED BLIND
INSTRUCTIONS
VERTICAL FRAME ×2
FLOOR FRAMING STEEL & TRIM
2×4 Flat Purlin2×4 Rafter
2×4 - 72" Lateral
2×4 - 72" Lateral
2×4 - 72" Lateral
2×6 - 72" Lateral
2×4 - 72" Lateral
2×4×12 Uprights
Double2×4×12Uprights
All FloorFraming2×6
Top of Floor 75½"
Frame Side
Frame Side
Frame Section
Frame Section
Opening may vary to fit personal preferences
Corner andGable Trim
Universal Ridgecap
Corner andGable Trim
Corner andGable Trim
J-Trim
J-Trim
Bottom Trim
Bottom Trim
2×4 - 69"
2×4 - 69"
2×6 Floor Framing
12'
70"
10"
22"
40"
6'
412
72"
24"
21"
16"typ
72"