‘65 Chevy Impala SS Convertible - Hobbicomanuals.hobbico.com/rmx/85-1555.pdf · ‘65 chevy®...
-
Upload
truongcong -
Category
Documents
-
view
220 -
download
3
Transcript of ‘65 Chevy Impala SS Convertible - Hobbicomanuals.hobbico.com/rmx/85-1555.pdf · ‘65 chevy®...
‘65 Chevy® Impala™ SS™ Convertible
KIT1555 85155500200
* REPEAT SEVERAL TIMES* A REPETER PLUSIEURS FOIS
* CEMENT TOGETHER* A COLLER
* ALTERNATIVE ASSEMBLY* ENSEMBLAGE ALTERNATIVE
* REMOVE AND THROW AWAY* A RETIRER ET JETER
* DO NOT CEMENT* NE PAS COLLER
* OPTIONAL PARTS* PIECES EN OPTION
* DECAL * DECAL COMANIE
When it came to cars, the big, shiny con-vertible was every kid’s idea of stylish trans-portation in the 1960’s. In the magazine ads, the TV commercials and on the middle of the dealership showroom floor, it was usually a flashy ragtop you first saw. Even though Dad would sometimes wind up with the more useful 4 door sedan or station wagon, the gleam in a youthful eye usually contained a convertible. For the American motoring public, Chevrolet® was their first choice. The best sell-ing car for many years, the completely new 1965 Impala™ was "longer, lower, wider" just like the advertising copy went. The ’65 model had less chrome than had been seen in years
which only accentuated the rounded, fluid lines of the new car. A wide range of powerplants were available from thrifty straight sixes to fire-breathing 409 V8s with 4 speed sticks. The hottest of the Impala lineup was the SS™. When you checked this box on the order form, you got bucket seats and floor mounted shifter instead of the bench seat and steer-ing column mounted transmission as well as special trim throughout. It’s no wonder that all these years later the ’65 Chevy convertible has become one of the most popular subjects for the "low ‘n slow" crowd of lowrider builders. Some visions of stylish transportation never really change.
If you have any questions or comments, call our hotline at: (800) 833-3570or, please write to:
Revell-Monogram Consumer Service Department, 725 Landwehr, Northbrook, Illinois 60062Be sure to include the plan number (85155500200), part number, description, your return address and phone number.
Visit our website: www.revell-monogram.com
REVELL-MONOGRAM, LLC Northbrook, IL. Copyright © 2003. All rights reserved.
* Study the assembly drawings.* Each plastic part is identified by a number.* In the assembly drawings, some parts will be marked by a star (★) to indicate chrome plated plastic.* For better paint and decal adhesion, wash the plastic parts in a mild detergent solution. Rinse and let air dry.* Check the fit of each piece before cementing in place.* Use only cement for polystyrene plastic.* Scrape plating and paint from areas to be cement-ed.* Allow paint to dry thoroughly before handling parts.* Any unused parts may be discarded.
READ THIS BEFORE YOU BEGIN
* Etudier les schémas de montage.* Chaque pièce en plastique est identifiée par un numéro.* Sur les schémas de montage, certaines pièces sont marquées d'une étoile (★) pour indiquer qu'elles sont en plastique chromé.* Pour une meilleure prise de la peinture et des autocollants,
laver les pièces en plastique avec une solution détergente peu concentrée. Les rincer et les laisser sécher à l'air.
* Vérifier que chaque pièce s'ajuste bien avant de la coller en place.
* N'utiliser que de la colle pour polystyrène.* Gratter les parties à coller pour enlever le chrome et la peinture.* Laisser la peinture bien sécher avant de manipuler les pièces.* Toute pièce inutilisée peut être jetée.
LIRE CE QUI SUIT AVANT DE COMMENCER
This optional paint guide is provided to detail this kit.
Ce guide facultatif de peinture est fourni pour détailler cette trousse.
Chevy Engine Orange
Flat Black
Silver
WARNING: PLASTIC GLUE COULD CATCH ON FIRE. IT COULD HURT YOU IF IT GETS ON YOUR SKIN OR IN YOUR EYES. CONTAINS: METHYL ETHYL KETONE. BE CAREFUL: Do not allow long contact with skin. Wash hands at once after use. Wear thick gloves when in use. Keep away from eyes. Do not smell or eat. KEEP OUT OF THE REACH OF SMALL CHILDREN.
FIRST AID: If glue gets in your eyes wash with clean water for 5 to 10 minutes. If glue gets on your skin, wash with soap and water for 5 minutes. If you start to feel weak, sick, or your speech becomes slow; go outside then wash hands and remove any clothing with glue on it. If you still do not feel better seek your doctors attention. For further health questions; contact a poison control center.
AVERTISSEMENT: LA COLLE PLASTIQUE RISQUE DE S’ENFLAMMER ET PEUT ETRE DANGEREUSE SI ELLE TOUCHE LA PEAU OU PENETRE DANS LES YEUX.COMPOSITION: METHYLETHYLCETONE.ATTENTION: Empêcher tout contact prolongé avec la peau. Se laver les mains immédiatement après utilisation. Porter des gants épais pendant l’utilisation. Ne pas approcher des yeux. Ne pas sentir ni avaler. Conserver hors de portée des jeunes enfants.CONSERVER HORS DE PORTEE DES JEUNES ENFANTS.
PREMIERS SECOURS: Si la colle pénètre dans les yeux, les laver à l’eau propre pendant 5 à 10 minutes. Si la colle adhère à la peau, laver celle-ci à l’eau savonneuse pendant 5 minutes. En cas de faiblesse, de nausées ou de diction pâteuse, sortir dehors, se laver les mains et ôter tout vêtement sur lequel adhère de la colle. Si l’on continue alors à ne pas se sentir bien, consulter un médecin. Pour d’autres questions en matière
Orange moteur Chevrolet
Noir mat
Argent
ENGINE ASSEMBLY1
22OIL PAN
33FRONT SUSPENSION
15EXHAUST MANIFOLD
14EXHAUST
MANIFOLD
32CHASSIS
32CHASSIS
★55ALTERNATOR
CHROME
★61BVALVE COVER
CHROME
18WATER PUMP
19FAN BELT
★67OIL FILLER
TUBECHROME
20FAN
★61AVALVE COVER
CHROME17INTAKE MANIFOLD
11LEFT ENGINE
HALFCHEVY ENGINE
ORANGE
FLAT BLACK
FLAT BLACK(BELTS)
SILVER
SILVER
16BCYLINDER
HEADCHEVY ENGINE
ORANGE
16ACYLINDER
HEADCHEVY ENGINE
ORANGE
12RIGHT ENGINE
HALFCHEVY ENGINE
ORANGE
COMPLETEDENGINE
ASSEMBLY
6RADIATOR
EXHAUST AND SUSPENSION ASSEMBLY 235
EXHAUST PIPE(DRIVERS SIDE)
FLAT BLACK
34EXHAUST
PIPE(PASSENGER
SIDE)
36REAR AXLE
37ALOWERED LEFT REAR SPRING
37C&DRAISED REAR
SPRINGS
41A&B RAISED REAR
SHOCKS
41DLOWERED LEFT REAR SHOCK 41C
LOWERED LEFT REAR SHOCK
38BLOWERED RIGHT
REAR SPRING
USE FOR RAISED VERSION
USE FOR RAISED VERSION
36BDRIVESHAFT
METAL TIPSNOTE: PICK A RIDE HEIGHT FOR THE SHOCKS
AND SPRINGS. ONCE THE RIDE HEIGHT IS PLACED YOU CANNOT BUILD THE OTHER VERSION
RAISED
LOWERED
RAISED
LOWERED
RAISED
LOWERED
INTERIOR ASSEMBLY 3
30 LEFT
DOOR PANEL
FLAT BLACK
24INTERIOR FLOOR
31RIGHT
DOOR PANEL
28SEAT FRONT
29SEAT BACK
★63SHIFT LEVER
CHROME
★8MASTER
CYLINDERCHROME
10FIREWALL
INTERIOR ASSEMBLY CONTINUED3
★69PRE AMPCHROME
40BATTERY PACKFLAT BLACK WITH SILVER CONTACTS
40BATTERY
PACKFLAT BLACK WITH SILVER CONTACTS
★★60HYDRAULIC
PUMPSGOLD PLATED
COMPLETEDDASHBOARD ASSEMBLY
27STEERING WHEEL
PAINT HORN RING SILVER
26STEERING COLUMN
25DASHBOARD
PAINT TRIM SILVER
SILVER STALK
BODY AND CHASSIS ASSEMBLY4
FIRST
SCREWSNOTE: TAB ON CHASSIS MUST
SLIDE INTO SLOTS ON METAL BODY BEFORE INSERTING SCREWS
LAST
WHEEL ASSEMBLY5FRONT REAR
★65FRONT
INNER WHEELCHROME
TIRE
METAL AXLE
TIRE
★★61WHEEL
GOLD PLATED
★★61WHEEL
GOLD PLATED
★66REAR
INNER WHEELCHROME
★★62KNOCKOFFGOLD PLATED
METAL PIN
★★62KNOCKOFFGOLD PLATED
85155500200
FINAL ASSEMBLY6
★70CONTROL
LEVERCHROME
17BRADIATOR HOSE
HOOD OMITTED FOR CLARITY
★68STOCK
AIR CLEANERCHROME
FIRST
NOTE: THE CONTROL LEVER MAY BE GLUED TO A SEAT OR THE CONSOLE IN THE INTERIOR, OR A PIECE OF
THREAD (NOT INCLUDED) MAY BE GLUED TO THE CON-TROL LEVER AND UNDERNEATH THE DASH SO THE CON-
TROL LEVER CAN BE DISPLAYED OUTSIDE THE CAR.