4-disconnect230kv
-
Upload
joemarievalcarcel -
Category
Documents
-
view
220 -
download
0
Transcript of 4-disconnect230kv
-
8/12/2019 4-disconnect230kv
1/4
E.1.4: DISCONNECT/EARTHING SWITCH
Technical Data Sheets E1-DSW-1/4
Name of Bidder:
Name & Signature of Bidder's Representative:
Designation:
E.1.4: DISCONNECT/EARTHING SWITCH 230KV
B.1 Technical Characteristics and Requirements
B.1.1 Technical Features and Requirements
Employers Requirement
a. Type (specify outdoor, indoor) Outdoor
b. Phase spacing (centerline-to-centerline), mm
c. Frequency, Hz 60
d. Supporting structure required No
B.1.2 Disconnect/Earthing Switch Ratings
a. Nominal System Voltage, kV 230
b. Rated Maximum Voltage, kV 245c. Rated Insulation Level
1. Short-durationPower Frequency Withstand
Voltage, dry 1minute, kV rms
2. Lightning Impulse Withstand Voltage , kV crest 900
d. Rated continuous current at System Frequency, A rms 1200
e. Rated Short-time Withstand Capability, kA rms. 38
f. Rated duration of short circuit current, sec 3
g. Rated Peak withstand current, kA 99
B.1.3 Disconnect/ Earthing Switch Physical Characteristics
a. Class Station Class, Outdoor
b. Pole construction Three
c. Mounting (specify vertical, horizontal) Horizontal
d. Mode of contact separation with reference to the
mounting plane (specify vertical, horizontal) Horizontal, center break
e. If horizontal, specify type (i.e. double column, three column) double column
f. If vertical, specify type (single column or pantograph, two
column) N/A
g. Earthing switch required (Yes, No) No
1. Type N/A
2. Current rating
a. Rated short circuit current, kA N/A
b. Rated Peak Withstand current, kA N/A
B.1.4 Support Insulator Characteristics
a. Rated Maximum Voltage, kV 245
-
8/12/2019 4-disconnect230kv
2/4
E.1.4: DISCONNECT/EARTHING SWITCH
Technical Data Sheets E1-DSW-2/4
Name of Bidder:
Name & Signature of Bidder's Representative:
Designation:
Employers Requirement
b. Creepage length, mm 6050
c. Type Porcelain
d. Color Brown
B.1.5 Operating Mechanism and Auxiliaries
a. Main Switch
1. Type Motor operated & manual
2. Mode of operation (specify remote, local, manual) remote, local & manual
3. Operating mechanism control voltage 125Vdc +10%, -15%
b. Earthing Switch (if required) N/A
c. Number of additional convertible auxiliary switches
above those normally required for disconnect/ earthing
operation 8A, 8B
B.1.6 Miscellaneous Accessories
a. Key Interlocks Yes
b. Position Indicator (both mechanical and light) Yes
c. Manual Closing Device provided Yes
d. Damping Device Yes
e. Arcing horn to be provided No
f. Line terminal connectors of disconnect switches to be
provided shall be suitable for: (specify size/ ampacity/
no. of conductors to be used)
Refer to Plan & Layout and Section
Drawings
g. Ground terminal connectors of disconnect switches to be
provided shall be suitable for: (specify size/ ampacity/
no. of conductors to be used)
> 125 mm2tin-annealed stranded
copper conductor, PVC insulatedh. Conduits from operating control mechanism down to
cable trench to be provided (Yes, No) Yes
B.2 Tests Requirements
a. Is disconnect/earthing switch design new or of previous
design with substantial changes in design and/or rating
(Yes, No) By Contractor
Note: If yes, certified design tests and reports are
required Yes
b. Design test and reports required Yes
c. Certified test design reports of prototype or duplicate
production type are acceptable Yes
d. Test reports of licenser instead of his own (Contractor)
is: (not acceptable, acceptable) not acceptable
e. Test frequency requirements 60 Hz
-
8/12/2019 4-disconnect230kv
3/4
E.1.4: DISCONNECT/EARTHING SWITCH
Technical Data Sheets E1-DSW-3/4
Name of Bidder:
Name & Signature of Bidder's Representative:
Designation:
Employers Requirement
f. Factory Routine Tests to be performed on each type and
voltage rating of the equipment (Yes, No) Yes
g. Factory Routine Tests to be witnessed by Employers
Representative (Yes, No) No
h. Required no. of personnel to witness routine tests N/A
B.3 Auxiliary Power Supply
B.3.1 The items listed below shall be designed to receive the following auxiliary power supply.
a. Motors 460 Vac, 3- , 60 Hz
b. Controls 125 Vdc, +10%, -15%
c. Indicating lights 125 Vdc, +10%, -15%
d. Space heaters 230 Vac, 1- , 60 Hz
e. Internal lights and convenience outlets 230 Vac, 1- , 60 Hz
B.4 Spares and Spare Parts
B.4.1 The following parts aside from those Contractor's recommended spare parts shall be furnished for
disconnect switches:
a. Unit(s) of insulator post column used for the disconnectswitch proposed. 1
b. Complete motor unit for the operating mechanism 1 unit
B.4.2 All spare parts shall be interchangeable with and identical in all respect to the original parts.
B.4.3 All disconnect/earthing switches of the same rating and type and its components shall be fully
interchangeable.
B.6 Tools
No particular tools are required.
C. Other Technical Data to be Filled-in by Contractor
C.1 The Contractor furnished data and information are included in this Specification to indicate the guaranteed
performance data, predicted performance, interface requirements and construction features of all Contractor
furnished equipment. The accuracy of such information and the compatibility of such information with
overall performance requirements specified by Employer are the sole responsibility of the Contractor.
-
8/12/2019 4-disconnect230kv
4/4
E.1.4: DISCONNECT/EARTHING SWITCH
Technical Data Sheets E1-DSW-4/4
Name of Bidder:
Name & Signature of Bidder's Representative:
Designation:
C.2 Environmental Considerations
C.2.1 In accordance with Paragraph 1.1.8 of the General Technical Requirements and the Technical Data
Sheets of Section E.1.1, the operating environment for this installation _(will , will not ) affect the life
expectancy of the components used in this equipment. If there will be an effect, the following componentswill be affected as follows:
Component Effect
_________________________ _________________________
_________________________ _________________________
_________________________ _________________________
C.3 Other Technical Data for Disconnect/Earthing switch
a. Country of Origin
b. Manufacturers
c. Type and Designation
d. Making Current of auxiliary contacts, A
e. Breaking current of auxiliary contacts, A
f. Power consumption of operating valves,
Watt
g. Power consumption of interlock valves or
magnets
h. Making current of motor protective circuitbreaker for disconnector
i. Breaking current or motor protective
circuit breaker for disconnector