Imenco AS Stoltenberggt. 1

P.O. Box 2143 N-5504 Haugesund

Tel. +47 52 86 41 00 Fax. +47 52 86 41 01

E-mail address: imenco@imenco.no

Homepage www.imenco.no

IMENCO 3-FINGER JAWS FOR TITAN II/III/IV AND ORION MANIPULATORS

Improve your manipulator work by using any of Imenco’s 3-finger jaws and your manipulative work becomes much easier and effi-cient! You can use either a loose grip or a fixed sturdy grip on your tools. The jaws set is delivered as a complete assembly.

More and more operators have found the 3-finger jaws assembly along with the fish-tail toolhandle the best solution for underwater manipulative tasks.

General Description: The Imenco 3-finger front adapter is made in high strength stainless steel and will make an exact fit to Schilling’s Titan II/III/IV and Orion manipulators. The front adapter assembly comes complete with ac-tuation plate and piston and all necessary gaskets and will replace the standard parallel grip by loose-ning the 6 bolts. The changeover is done in less than half an hour! A majority of the ROV operators prefere and has installed Imenco’s 3-finger jaw on their manipulators. There are hundreds of Imenco jaws at work with a number of operators in the North Sea and elsewhere. Imenco holds complete sets and spare parts in stock at all times, making delivery over-night possible. We are also holding jaw fingers and actuation bearings for Rigmaster manipulators along with shearpin shafts for Schilling TII/III/IV azimuth shoulder actuator. Fishtail grips are stocked.

Specifications:

Maximum opening between tips: 165 mm

Maximum length mounted: 200 mm Diameter of adapter: 115 mm

Finger width 37 mm