Installation Instruction Applicable Connector:

3192-6004 TCAT-RJ-45-25

1. Slide rubber boot on the cable.

2. Trim the cable jacket 30mm using the RJ-45 crimp tool (razor blade), Be careful to avoid to nick the cable outer braid

Installation Instruction

3. Flip the cable outer conductor, include the wire braid and tape braid

4. Trim the cable outer conductor over insulator 5.0mm, flaring the braid on the cable jack, remove aluminum tape

5. Cut the cable insulator bolster using the tool diagonal pliers.

Installation Instruction

6. Arrange wires base on T568A or T568B, put wires through the plastic spacer. Cut wire end in line.

7. Insert cable sub assembly into connector body until wires terminal to connector housing end.

8. Crimp the cable jacket 30mm using the RJ-45 crimp tool.

Installation Instruction

9. Crimp connector metal foot on the cable outer wire braid.

10. Slide rubber boot on the connector housing.

11. Install another side connector according to the above steps 1~10. Test the Jumper for continuity.

Installation Instruction

Tools list: