We’d love to hear from you. Scan with your Walmart app and let us know what you think.

Let’s Get Started! The Third Step Battery Replacement for the Remote Control

The Second Step Battery Replacementfor the Remote Control

The First Step Remove the Plastic strip from the Remote Control

Here’s what you’ll need to get set up: 030201

Back

Controls

Ruler

Drill

Screwdriver

Level

TV

Computer, Tablet or Smartphone

Remove the plastic strip from the battery if the battery is being used for the first time. It is located at the bottom rear of the remote control.

Replace with a new battery, The remote control requires a CR2025, 3V Lithium battery, Insert the battery holder back into the remote control.

Slide and hold the battery release tab in the direction of the arrow. Pull out the battery holder

30” 2.0-CHANNEL SOUNDBAR

Quick Start Guide

But Wait ... There’s More! The Fine Print

Hints and TipsIf a problem occurs, it may often be due to something very minor. The following table contains various tips:

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equlpment complles with FCC radiation exposure limits set forth for anuncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:§ Reorient or relocate the receiving antenna.§ Increase the separation between the equipment and receiver.§ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.§ Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.

When switching to another channel, the Bluetooth will be in disconnected status.

Ensure the mains adapter is connected securely at both ends.

The plugs and sockets anr dirty. Wipe them with a cloth slightly moistened with an appropriate non-abrasive cleaning solution.

Make sure that the ON mode is selected.

Use the remote control near the unit.Point the remote control at the remote sensor on the unit.Replace the battery in the remote control with a new one.Remore any obstacles between the remote control and the unit.

When LED indicator is flashing slowly, the Bluetooth will be paired and be in disconnected status.

When LED indicator becomes solid, the Bluetooth will be connected successfully with a prompt tone.

No power

If any functional abnormality is encountered, unplug the unit from the mains socket and reconnect it again.

The remote controlis not functioning

Loud hum or noise is heard

Problem Solution

What’s in the Box? Check to make sure you have everything below.

1. Main Unit2. Remote Control3. Instruction Manual4. Power Adapter5. 3.5 to 3.5mm Stereo Audio Cable6. Optical Cable

1. Speaker2. LED Indicator3. Remote Control Sensor4. AUX IN Port5. OPTICAL Port6. DC IN Port7. Button Switches the unit between ONand STANDBY modes8. SOURCE Button Selects the input source9. VOL- Button Decreases the volume10. VOL+ Button lncreases the volume

TM

1

2

4 5

4

6

5

330” 2.0-CHANNEL SOUNDBAR

Quick Start Guide

Get to Know Your 30'' 2.0-CHANNEL SOUNDBAR

1 2 3Front

6

7 8 9 10

Quick Start Guide_Ver.01 Rev.05/18/19Unfold dimension：570X106mmMaterial：80g matt art paperPrinting：2C，double sides

100004120