2015 working solution nexiq usb link 3 lights keep flash fast
-
Upload
chinasinoyobd2 -
Category
Technology
-
view
342 -
download
20
Transcript of 2015 working solution nexiq usb link 3 lights keep flash fast
2015 Working solution: Nexiq USB link 3 lights keep flash fast
This post supply newest working solution for the issue that NEXIQ USB link get error code 134 after get firmware update.
Symptom:When connect the Nexiq, The power light, data light and Fault light keep flash
fast.
Watch video at: https://mega.co.nz/#!gdQjnLqB!Ik-DiBub7UJUZ42JB5z9lWZBZ-oK56jQL8QfZHvGCHQ
The reason for this symptom:Users download and install the software from NEXIQ USB link official site, then have USB-Link firmware update.
Working Solution:Step 1. Replace the chip U56, there are 3 spare U56 chip in the package.
Step 2.Uninstall the driver download from NEXIQ USB link official site, then reboot. Video demo at:https://mega.co.nz/#!ocoiFJLJ!EeGPSSEqF0LZrxlwchyugUFDpDPD98Gmzc83FCZknCY
Note: be sure to clean up all software from official site, otherwise USBlink will be abnormal.
Simple steps shown in the following 3 pictures:
Step 3. Install "USB-Link8500" driver, download at: https://mega.co.nz/#!1MgVFZjK!tx2H2X9ydI0uSCCYOWyLm9bCPeQf0JRBmv9jz2HbGcE Then restart your computer.
Finally, NEXIQ USB-LINK work well, the first indicator light turn green.