6-53 www.powercommander.com 2007-2008 Kawasaki Z750/1000 - Ignition module - 1

2007-2008 Kawasaki Z750/1000

Installation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993

Parts List

1 Ignition module1 Installation Guide2 Velcro® Strip1 Alcohol Swab

You can also download the Power Commander software and latest maps from our web site at:www.powercommander.com

The ignition MUST be turned OFF before installation!This module is intended to be used in conjunctionwith Power Commander 227-410

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Before this module can be used the Power Commander may need to be updated.

(see included instructions)

1 Remove the main seat and passengerseat.

2 Remove the right hand frame cover(Fig. A).

3 Remove the fuel tank.

4 Lay the Ignition Module in the tailsection temporarily. Route the har-ness of the Igniton Module towardsthe front of the bike ( Fig. A).

5 Route the harness along the frame.

6 Unplug the stock wiring harness at thesub-connector for the coils sticks(Fig. B). This connector is locatednext to the #4 coil stick.

7 Plug the connectors from the PCIII in-line of the stock wiring harness(Fig. C).

Fig.

AFi

g. B

Fig.

C

6-53 www.powercommander.com 2007-2008 Kawasaki Z750/1000 - Ignition module - 2

PCIIIconnectors

Remove this cover

Unplug

Stock connector

8 Locate the crank pickup coil connec-tor. This connector is located on theright rear of the air box. This connec-tor is behind the cover you removedin step 2.

For the Z750 you will need to removethe bolt that holds the connector inplace to gain accesss

9 Unplug the crank connector (Fig. D).

12 Attach the ground wire of the IgnitionModule to the ground wire near thethermostat housing (Fig. F).

This is the same ground location asthe PCIII harness.

Fig.

DFi

g. E

6-53 www.powercommander.com 2007-2008 Kawasaki Z750/1000 - Ignition module - 3

Ground wire from PCIII

IM harnessground wire

Unplug

10 Plug the connectors from the PCIII in-line of the stock wiring harness andcrank connector (Fig. E).

11 Reinstall the frame cover.

Stock connector

PCIIIconnectors

Fig.

F

Fig.

G

6-53 www.powercommander.com 2007-2008 Kawasaki Z750/1000 - Ignition module - 4

13 Install the Ignition module on top ofthe Power Commander. The velcrocan be used if necessary to keep theunit in place.

14 Plug the white 10 pin connector fromthe ignition module into the expansionport of the PCIII. If you are using aquickshifter (or other accessory) thenunplug that from the PCIII and con-nect to the expansion port of the ign-tion module harness.

15 Bolt the fuel tank back into placemaking sure that the harness does notget pinched.