Dodge BuildShare Dodge BuildShare - McGraw-Hill Construction
2005-07 Dodge Magnum - Scosche · 2015. 10. 9. · 2005-07. Dodge Magnum Images Front Speakers Rear...
Transcript of 2005-07 Dodge Magnum - Scosche · 2015. 10. 9. · 2005-07. Dodge Magnum Images Front Speakers Rear...
+12v Constant = Gray/Green +12v Acc. Switch = -12v Chassis Ground= Black/Gray +12v Illumanation = +12v Dimmer = Amp Remote = Can-Bus = White/Orange & White
LF+ = Gray/PurpleLF- = Gray/Yellow
RF+ = Green/Purple RF- = Green/Yellow LR+ = Green/Orange LR- = Green/Yellow RR+ = Yellow/Pink RR- = Green/Brown
Dash Type : Din and 1/2/Double DinAftermarket Type: Single/Double DinKit: CR1286B/CR1289BHarness: CR03SRAntenna Adapter: CRAB/CRARB
Interface Adapter(s): Can-Bus Protocol (TBA)
About the Vehicle
Make: DodgeModel: MagnumYear: 2005-07
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
Dodge Magnum
NOTES
Dimensions:
Dimensions: W= L= D=
NOTES
Rear Deck: 6x9'' MidrangeSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 screws securingspeaker.
Standard/OptionalSix-speaker, 288-watt Boston Acoustics sound system.CD PlayerNavigation SystemMP3-compatible In-dash CD changerDVD Player
Ampli�er Locations:Behind Drivers Side Knee Bolster.
W= L= D= 3.35''
Type: Standard Audio System Location: At Speakers
Front Dash : 3'' FullrangeLower Door: 6X9” MidbassSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 screws securingspeaker.
Speaker Sizes
The front dash 3'' speaker is standardonly on the Boston Acoustic System.
2005-07
Dodge Magnum
Images
Front Speakers
Rear Speakers
Radio removal
Front Speakers
Rear Speakers
Using a PRT remove both "A" pillars.2. Using a PRT pry upwards on the dash panel torelease the (11) clips securing the dash panel to the top of the dash.3. Extract (2) PHS securing the speaker to the dash.
1. Remove the rubber pad just in front of the shifter.Extract (2) PHS from underneath the pad.2. Using a PRT remove the trim around the shifter.3. Using a PRT remove the whole trim panel that is around the shifter that goes to the bottom of the ash tray.4. Using a PRT remove the ash tray trim panel.5. Using a PRT remove the trim around the radioand A/C controls.6. Extract 4 PHS securing the radio to the dash.Disconnect and remove.
Radio
Dash Fullrange
Recommended: Disconnect negative battery cable
A Pillar Tweeter
Door Speakers1. Using a hook tool lift the screw cover on the door release handle panel. Extract (1) PHS behindthe cover.2. Using a hook tool lift the screw cover just belowthe arm rest. Extract (1) PHS from behind the cover.3. Using a small center punch push in the pop-tabrelease pins on outer rim of door panel. (1) on frontsill, (2) on rear sill.4. Extract (4) PHS from lower door panel.5. Using a PRT remove door panel. Disconnect and remove.6. Using a T-20 torx bit extract (4) T-20 screwssecuring speaker to factory speaker adapter.Disconnect and remove.
Door Speakers Using a PHS driver remove (1) PHS securingspeaker cover panel to rear side panel. Removespeaker panel.2. Extract (4) T-20 screws securing speaker tofactory speaker adapter. Disconnect and remove.
2005-07