1600 Series Operation (See Installation and Operation Manual for detailed instructions)
description
Transcript of 1600 Series Operation (See Installation and Operation Manual for detailed instructions)
1600 Series1600 SeriesOperation Operation
(See Installation and Operation Manual for detailed instructions)(See Installation and Operation Manual for detailed instructions)
2
FoamPro 1600 SeriesFoamPro 1600 Series
• Fully automatic• Class A foam ONLY• Proportions
between 0.1% to 1%
• Flowmeter standard (1", 1-1/2" or 2" tee)
• Operators control panel
3
WaterTank
WaterPump
Flowmeter
FoamTank
Line Strainer
Electronic DirectElectronic DirectInjection ProportionerInjection Proportioner
Check Valves
MultipleDischarges
4
• Controller includes:– Operating instructions– On/Off switch– Injection rate control
– Adjustable from 0.1%-1.0% – System Status Light
Features And OperationsFeatures And Operations
5
• System Status Light Codes:– Light flashes then goes out
– System ready to operate– One flash per second
– Simulated flow mode engaged– Remove power;
disengaged automatically– Solid light
– No concentrate– Two flashes per second
– Concentrate level low– 5 flashes per second
– Electrical error
Features And Operations Features And Operations (cont.)(cont.)
6
Motor driver module Circuit
breaker switch
“UP” for normal
operation
Simulated flow
momentary switch. Up
once, engages. Up again,
disengages
Features and Operations Features and Operations (cont.)(cont.)
7
• Enter “SIMULATED FLOW”
• Valve to “CAL/FLUSH”• Turn panel switch “ON”• Run pump until
concentrate flows from dump line
Purging AirPurging Air
8
• Turn control panel to “OFF” position
• Return valve to “INJECT”
• Exit “SIMULATED FLOW” by switching momentary switch up
Purging Air Purging Air (cont.)(cont.)
9
• Foam concentrate pump – Grease fitting every 8 hours of
operation
• Foam concentrate strainer – Clean out regularly– If little or no foam concentrate is
injected while system is running, check for clogged strainer
– Purge air from foam pump afterwards
MaintenanceMaintenance