1. Introduction

A. Hand & Power Tool Injuries

1. Account for approximately 6% of all compensable injuries.

2. Common types of injuries include:

a. eye injuries b. hand/finger injuries from

struck-by

1. Introduction

B. Causes of Injuries

1. Miss-use of tools

2. Defective tools

II. Preventing Hand & Power Tool Injuries

A. Tool Selection

1. Ideal tool can complete the joband not cause any discomfort tothe user.

II. Preventing Hand & Power Tool Injuries

2. Tool selection criteria:a. ergonomic designb. quality of constructionc. controls for tool vibrationd. actuating means of toolse. consider work methodsf. user input

II. Preventing Hand & Power Tool Injuries

B. Proper use of tools

1. Select the proper tool for the job2. Inspect the tool prior to use3. Wear the proper PPE4. Use the tools as intended5. Place tools in safe areas when

not in use

II. Preventing Hand & Power Tool Injuries

C. Centralized Tool Control

1. Assures uniform inspection of tools

2. Records can be obtained on damaged tools

3. Assure proper PPE is available

4. Improve the handling and use of special tools

II. Preventing Hand & Power Tool Injuries

D. Common Hazards of Hand Tools

1. Chisels

2. Saws

3. Knives

4. Wrenches/Pliers

II. Preventing Hand & Power Tool Injuries

D. Common Hazards of Hand Tools

5. Screw Drivers

6. Hammers

II. Preventing Hand & Power Tool Injuries

E. Common Hazards of Power Tools

1. Electric Tools

a. electric shock

II. Preventing Hand & Power Tool Injuries

2. Pneumatic tools

a. Hazards from air lines, noise, vibration

Note: If air hose is > 1/2" a safety excess flow valve must be installed at the source.

II. Preventing Hand & Power Tool Injuries

3. Power Actuated Tools

a. Require a license to operate

b. Can not be operated in explosive or flammable locations.

c. Interlocks required on trigger

d. Muzzle of tool must be protected

II. Preventing Hand & Power Tool Injuries

F. Guarding the PO of Power Tools

1. Circular saws

a. Retractable guard required below the face plate

II. Preventing Hand & Power Tool Injuries

F. Guarding the PO of Power Tools

2. Abrasive Sanders

a. Guards at end of sander to protect nip points

II. Preventing Hand & Power Tool Injuries

3. Portable grinders

a. Guarding required on all wheels > 2"

b. Ring testing of grinding wheels prior to mounting

Routers

Sawzall

Planer

Sanders

Saws

Cut off saw Jig saw Compound miter saw

Drills

Electric Hammer