1 CSWA 20resources/default.htm.
29
1 CSWA http://www.eng.uwo.ca/designcentre/CAD%20resources/default.htm
-
Upload
posy-flynn -
Category
Documents
-
view
264 -
download
0
Transcript of 1 CSWA 20resources/default.htm.
1
CSWA
http://www.eng.uwo.ca/designcentre/CAD%20resources/default.htm
2
DIMENSIONING AND TOLERANCING
3
prismatic.sldasm
4
DIFFERENT TYPES OF FIT
Clearance fit
Limits of size defined such that a clearance always results when mating parts are assembled
Interference fit
Limits of size are so prescribed that interference always results when mating parts are assembled.
Transition fit
Limits of size are so prescribed that either clearance or an interference may results when mating parts are assembled
Line fit
Limits of size are so prescribed that surface contact or clearance may result when mating parts are assembled
5
BASIC HOLE SYSTEM
In the basic hole system the minimum (lower limit) hole size is taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type of fit (to suit the hole).
6
BASIC SHAFT SYSTEM
In the basic shaft system the maximum (upper limit) shaft size is taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of fit (to suit the shaft).
7
In the basic hole system the minimum (lower limit) hole size is taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type of fit (to suit the hole).
In the basic shaft system the maximum (upper limit) shaft size is taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of fit (to suit the shaft).
BASIC SHAFT OR BASIC HOLE?
8
“Shaft”
“Hole”
-- =
=
What type of fit is this?
IDENTIFY FIT SYSTEM
9
IDENTIFY FIT SYSTEM
10
IDENTIFY FIT SYSTEM
Basic hole
More commonly used
Basic shaft
Less commonly used
11
Shown are limit tolerances
IDENTIFY FIT SYSTEM
12
Surface roughness for different manufacturing methods
http://mdmetric.com/pdf/surfruff.pdf
13
14
Φ
Basic hole fits
15
Φ
Basic shaft fits
16
Description of preferred fits
17
ANSI PREFERRED HOLE BASIS METRIC CLEARANCE FITS
Pages 312, 313, 314, 315
ANSI PREFERRED SHAFT BASIS METRIC CLEARANCE FITS
Pages 316, 317, 318, 319
Engineering Design GraphicsJames LeakeJacob Borgerson
18
cylindrical_metric.sldasm
Nominal diameter 25mm
Btw. what is wrong with this assembly?
19
Loose running fit for nominal diameter 25mm preferred hole basic
20
Free running fit for nominal diameter 25mm preferred hole basic
21
Close running fit for nominal diameter 25mm preferred hole basic
22
Sliding fit for nominal diameter 25mm preferred hole basic
23
Locational clearance (line fit) for nominal diameter 25mm preferred hole basic
24
Locational transition fit for nominal diameter 25mm preferred hole basic
25
Locational transition fit for nominal diameter 25mm preferred hole basic
26
Locational interference fit for nominal diameter 25mm preferred hole basic
27
Medium drive fit for nominal diameter 25mm preferred hole basic
28
Force fit for nominal diameter 25mm preferred hole basic
29
Hole is always the same: H7
We obtained the desired fit by changing shaft tolerance
