089112-0008
Transcript of 089112-0008
-
7/28/2019 089112-0008
1/2
INSTRUCTION MANUAL
RESISTANCE GAUGEManual ref : 0008 573.089.110
Dear customer,
We thank you very much for purchasing an accessory from KREMLIN range.
We have taken every care, from original design to final manufacture, to ensure that this product gives you
complete satisfaction.To get the best result, safe and efficient operation of your resistance gauge, we advise you to read andmake yourself familiar with this instruction and service manual.
1. EC AND EX DECLARATION OF CONFORMITY
The manufacturer : KREMLIN S.A. with assets of 5 520 000 euros150, avenue de Stalingrad 93240 STAINS FranceTl. : (33) 1.49.40.25.25 Fax (33) : 1.48.26.07.16
Herewith declares that :
Resistance gauge
Is in conformity with the following provisions :
EC - Machinery Directive (directive 89/392/EEC).
EC - Directive of Electromagnetic Compatibility (directive 89/336/EEC).Harmonized European standards : EN 50081-1 and EN 50082-1
Established in STAINS, on September 1st, 1999.
Daniel TRAGUS
President - C.E.O
2. DESCRIPTION
This instrument is designed to measure the material resistivity for the electrostatic coating application.
The resistance of the material is displayed by a series of LEDs.
KREMLIN - 150, avenue de Stalingrad - 93240 STAINS - FRANCETlphone : 33 (1) 49 40 25 25 Tlcopie : 33 (1) 48 26 07 16
-
7/28/2019 089112-0008
2/2
KREMLIN Notice : 573.089.110
3. CHARACTERISTICS
Supply .................... 2 batteries - 9 volts. Weight ............................. 385 g / 13.6 ozDimensions ............ 102 x 65 x 42 mm / 4 x 2.6 x 1.6" Probe connection ............ 2 plugs
4. OPERATIONConnect the probe to the resistance gauge.
Check if the resistance gauge is operating properly :
The probe pointed upward, press the button the upper yellow LED should be illuminated.
Hold the probe tight between the fingers the red LED should be illuminated.
Dip the probe end into the paint.
Press the button and observe the LEDs being illuminated :
The illuminated green LEDs denote that the material resistivity enables the maximum gun performance.
The illuminated yellow LEDs denote that the material resistivity reaches values limiting the gunperformance.
The illuminated red LED denotes that the material resistivity reaches a low value (conductive paint)which dramatically reduces gun performance. In this case, an electrostatic installation designed forconductive material is necessary.
Thoroughly clean the probe after each measure.
5. RESISTIVITY ACCORDING TO THE COLORS OF THE LEDs
Yellow
Yellow
Yellow
Yellow
Green
Green
Green
Green
Yellow
Red
0 5 10 15 20 25 30 35 40 45 m
cm
6. PARTS LIST OF THE RESISTANCE GAUGE - P.N : 048.070.000
1 probe P.N : 048.060.115
2 batteries - 9 V P.N : 901.203.004